Chemin'Arte Vidrio User manual

www.cheminarte.com
ELECTRIC HEATER
INSTRUCTION MANUAL
Model: Vidrio Black and White ref 182/183
Electrical Parameter
Power supply: AC220-240V
Frequency: 50-60Hz
Power: 2000W
NOTE: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Important

Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided
that it has been placed or installed in its intended normal operating position and they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
CAUTION—Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
WARNING: In order to avoid overheating, do not cover the heater.
Operating Instructions
Note: Ensure the circuit breakers for the power supply are turned on.
The heater controls are located right of the heater outlet.
O/I:Press this switch for main power function. The heater is preset to start with flame effect.
Press again will stop the main power function.
Once the heater is switched off, the unit will keep working with air flow for 60 more seconds.
1000W: For low heat function –Press this switch while the O/I switch is in the ON position. The
heater will provide low heat level. Press once again to stop the low heat level function.

2000W: For high heat function –Press this switch while the O/I switch and the 1000W switch are
in the ON position. The heater will provide high heat level. Press once again to stop the high heat
level function.
Temperature Control: To adjust the temperature to your individual requirements, turn the
temperature control dial to the right (clockwise) to increase the temperature and to the left
(counter clockwise) to decrease the temperature. When desired ambient temperature is reached,
the heater will automatically stop heating. When the ambient temperature drops below the desired
temperature 2°C, the heater will resume heating.
Note: When the O/I switch is turned off, all other functions will stop even though the switches
may be in the ON position.
Maintenance:
WARNING: Completely disconnect power before attempting any maintenance or cleaning,
to reduce the risk of fire or electric shock. Maintenance should only be performed by a
certified technician.
Cleaning:
Before cleaning any parts of the fireplace make sure to first turn off the controls and then
unplug the unit from power source.
CAUTION: Wait until the unit has completely cooled before attempting any cleaning.
Cleaning Glass Panel: Remove dust with clean dry cloth. Remove fingerprints and
other marks from glass door by using a clean damp cloth. Do not use abrasive cleaners or
spray liquids on glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use
abrasive cleaners or spray liquids on these surfaces.

Information requirements for electric local space heaters
Model identifier(s): NDF-RO17W
Item
Symbol
Value
unit
Item
unit
Heat output
Type of heat input, for electric storage local
space heaters only (select one)
Nominal heat
output
Pnom
2,0
kW
manual heat charge control, with
integrated thermostat
[no]
Minimum heat
output
(indicative)
Pmin
0
kW
Manual heat charge control with
room and/or outdoor temperature
feedback
[no]
Maximum
continuous heat
output
Pmax,c
2,0
kW
Electronic heat charge control with
room and/or outdoor temperature
feedback
[no]
Auxiliary
electricity
consumption
Fan assisted heat output
[no]
At nominal heat
output
elmax
0
kW
Type of heat output/room temperature
control (select one)
At minimum
heat output
elmin
0
kW
single stage heat output and no room
temperature control
[no]
In standby
mode
elsb
0
kW
Two or more manual stages, no room
temperature control
[no]
with mechanic thermostat room
temperature control
[yes]
with electronic room temperature
control
[no]
electronic room temperature control
plus day timer
[no]
electronic room temperature control
plus week timer
[no]
Other control options (multiple selections
possible)
room temperature control, with
presence detection
[no]
room temperature control, with open
window detection
[no]
with distance control option
[no]
with adaptive start control
[no]
with working time limitation
[no]
with black bulb sensor
[no]
Contact details:
www.cheminarte.com