Cisco 8201 User manual

Replace Chassis Components
•Replace Fan Modules for Cisco 8201 Routers, on page 1
•Replace Power Supply, on page 3
Replace Fan Modules for Cisco 8201 Routers
The fan module is designed to be removed and replaced while the system is operating without presenting an
electrical hazard or damage to the system. Please keep the replacement fan modules ready prior to attempting
this task.
The routers support FAN-1RU-PI (port-side intake airflow) and FAN-1RU-PE (port-side exhaust airflow)
fan modules.
Note
The airflow direction must be the same for all power supply and fan modules in the chassis.
Note
Step 1 To remove a fan module, follow these steps:
a) Press two latches on the fan module and grasp the handle of fan module.
Replace Chassis Components
1

Figure 1: Cisco 8201 Router —Remove Fans
Latched fan module1
b) As you simultaneously press the latches pull the fan module fully out of the chassis.
Step 2 To install a fan module, follow these steps:
a) Hold the fan module with the LED at the top.
b) Align the fan module to the open fan tray slot in the chassis, and press the module all the way into the slot until the
left and right latches click and are locked on the chassis.
Replace Chassis Components
2
Replace Chassis Components
Replace Fan Modules for Cisco 8201 Routers

If the fan module does not go all the way into the slot, do not force it. Remove the fan module and verify
that it is the correct type for your router and in the correct orientation. To verify the status of fans and the
speed, use the show environment fan command.
Note
c) If the chassis is powered on, listen for the sound of the fans in operation. You should immediately hear them in
operation. If you do not hear them, ensure that the fan module is inserted completely in the chassis.
During the fan module replacement, the other fans adjust their speed to allow for proper initialization of
the new module. When you insert a new fan module, the fans may run at lower or higher speeds for a few
minutes.
Note
d) Verify that the fan module LED is green. If the LED is not green, one or more fans are faulty. If this situation occurs,
contact your customer service representative for replacement parts.
Replace Power Supply
Use this procedure to replace the AC or DC power supply units. Be sure to power down the fixed configuration
PDU (power distribution unit) before removing it from the chassis.
Step 1 If the power supply is connected to a AC or DC circuit, shut off the circuit at the circuit breaker.
Step 2 Disconnect the PSU cable.
Step 3 Press the tab inward to unlatch the PSU, and pull the handle to remove the PSU.
Step 4 Insert the new PSU.
If the PSU does not go all the way into the slot, do not force it. Remove the PSU and verify that it is the correct
type for your router and in the correct orientation.
Note
Step 5 Connect the PSU cable.
Step 6 If the power supply is connected to a DC circuit, turn on the circuit breaker for the DC power source. After replacing the
PSU, verify the power using the show environment power command.
Replace Chassis Components
3
Replace Chassis Components
Replace Power Supply

Figure 2: Cisco 8201 Router —Remove Power Supply
Power supply1
Replace Chassis Components
4
Replace Chassis Components
Replace Power Supply