Cisco RV130 User manual

How to Reboot and Reset to Factory Default
Settings on the RV130 and RV130W
Objective
The factory default reset erases all configuration settings that have been modified by the
user, and restores the device to its original settings. This may be helpful if you lose the
password to a device and wish to regain access. Performing a reboot restarts the device with
a saved configuration.
The objective of this document is to show you how to reset to factory default settings and
how to reboot the RV130 and RV130W.
Applicable Devices
• RV130
• RV130W
Software Version
• v1.0.1.3
Reset to Factory Default Settings
The router can be reset to the factory default settings through either the web configuration
utility or the reset button on the back of the router.
Reset with the use of the Web Configuration Utility
Step 1. Log in to the web configuration utility and choose Administration > Restore
Factory Defaults. The Restore Factory Defaults page opens:
Step 2. To reset the device, click the Default button. This will erase all current
configurations.

Step 3. A confirmation window appears. Click Yes to continue.
Step 4. After the reboot is completed, login with the default credentials. The default
username is cisco and the default password is cisco.
Hardware Reset
Step 1. Press the Reset button located at the back of the device with a pin for approximately
15 seconds or until the power light on the front of the device starts flashing.
The Router reloads and is set to the default configuration settings.
Step 2. Login with the default credentials. The default username is cisco and the default
password is cisco.
Rebooting the Device
The router can be reset to the factory default settings through either the web configuration
utility or the power button on the back of the router.
Reboot with the use of the Web Configuration Utility

Step 1. Log in to the web configuration utility and choose Administration > Reboot. The
Reboot page opens:
Step 2. Click the Reboot button to reboot the device.
Step 3. After the reboot is completed, login with the saved administration credentials.
Hardware Reboot
Step 1. Press the power button to turn off your device. After 15 seconds have passed, press
the power button a second time to power the device back on.
Step 2. After the reboot is completed, login with the saved administration credentials.