Clam Corp Clam 2000 8309 User manual

Clam Corporation, Inc. Manual – 102181
Model No.
- 8309 -
Specifications
Set-Up
ŀHeight: 60 inches
ŀLength: 72 inches
ŀWidth: 48 inches
Collapsed
ŀHeight: 6 inches
ŀLength: 36 inches
ŀWidth: 48 inches
ŀWeight: 45lbs
- Clam Customer Service Information -
NOTICE!! Once used, this shelter cannot be returned to the store. If you have a
Warranty Claim, please contact Clam Corporation Customer Service by email
inquiry or direct by calling:
ŀCustomer Service Hrs: - 8am to 4pm, Mon. - Fri. Central Standard Time
ŀClam Corporation, Inc.
600 Clydesdale Trail
Medina, MN 55340
ŀPhone - 763-231-4120
ŀFax - 763-231-4121
ŀWebsite – www.clamcorp.com
ŀEmail – [e-mail]

2
- Set-Up Instructions -
ŀUnfold the unit and unzip the doors at both ends. Locate and remove the folded Flexible Rods
and Latch Clips from the unit.
ŀThrough the doorway of one end, grasp the center of the nearest Hoop Tube and pivot it
upwards towards you into a vertical position. Next pull the same Hoop Tube straight up, sliding
it until the holes near the ends are engaged by the Spring Buttons of the Canopy Poles. Lay the
erected Hoop Tube down onto the unit.
ŀGo around to the opposite doorway and erect the other Hoop Tube in the same fashion. Lay both
erected Hoop Tubes against one another.
102190 Tent (not shown)
101682 Flexible Rod
102191 Hoop Tube
101168 Latch Clip
101152 Canopy Pole
Spring Button
101150 Hole Cover
101116 Molding

3
- Set-Up Instructions (cont.)-
ŀFrom outside the unit, unfold the Flexible
Rods into a straightened position.
ŀThrough either doorway, reach into the Tent
and find a Rod Pocket located on either
corner of the Hoop Tube coming from the
opposite side of the unit. Going through the
doorway, slide one end of a Flexible Rod into
this Rod Pocket, using the Flexible Rod to
push the Hoop Tube into its vertical position.
Use one hand to hold it steady and the other
to rotate the other Hoop Tube into its vertical
position, before inserting the other end of the
Flexible Rod into its corner Rod Pocket
located diagonally across the unit. With the
Flexible Rod now bowed downward, secure
the center to the Velcro located in the center
Roof Panel of the Tent.
ŀLocate the other Flexible Rod and insert its
ends into the remaining Rod Pockets, then
resecure the Roof Panel Velcro to include this
Flexible Rod also.
ŀAt the crossing location of the Flexible Rods,
use your fingers to push the Rods upwards,
reversing the bow direction and tightening the
surrounding Tent.
FETY INSTRUCTIONS
- Take-Down Instructions -
ŀRemove the Flexible Rods, fold them up, and
place them both onto the same floor half.
ŀOne Hoop Tube at a time, use your fingers to
disengage the Spring Buttons and collapse
each Hoop Tube before rotating them down
onto their respective floors.
ŀGo around the unit and gather the Tent
material onto the floor, so that when folded,
all will be protected between folded floors.
ŀFold the empty floor half onto the floor half
containing the folded Flexible Rods. Use the
provided Latch Clips to secure the unit
together by placing them on the outside
edges. The Eyelets of the Latch Clips may be
used as an anchor point for roping down gear
on top of the unit while pulling to your fishing
destination.
Notice!! - The Tow Rope of this unit is intended for walking use only. Any damage incurred
from pulling behind a motorized vehicle is not covered under warranty.
Flexible Rod
Rod Pocket

4
- Safety Instructions -
Please fully understand and follow all safety instructions as outlined. Failure to do so could
result in severe injury or death.
ŀDo not use open flame heaters in your ice shelter. Injury or death may result from fire if tent
fabric is exposed to open flame. The tent is not fireproof, but the fabric is treated with a fire
retardant that meets CPAI-84 specifications. Application of any foreign substance may render
the flame retardant properties ineffective. Ice Armor fabric will melt when contact is made with
hot surfaces (i.e., heaters).
ŀDeath from asphyxiation may result from use of oxygen depleting heaters. Open all vents for
fresh air ventilation.
ŀNever leave shelter unattended when set up.
ŀDue to the increase in traffic (snowmobiles, autos, etc.) on area lakes, ice fishing can be
hazardous at night. If you choose to fish at night or in poor visibility conditions, be sure to take
precautions with lights or reflectors to show drivers your whereabouts. Night time: exterior
reflectors must be visible to reduce risk of collisions.
- Warranty -
Clam Corporation, Inc. warrants to the original retail purchaser that all Clams are free from
manufacturer’s defects for one (1) year from the date of original purchase. Warranty does not cover
cracked windows, tent tears, broken or bent hoops due to high wind weather conditions or
unattended use. Clam Corporation will replace or repair any part found defective within the one (1)
year time limit. All parts must be returned to Clam Corporation, Inc. Before returning any parts, you
must first call or write and acquire a return authorization. All returns must be returned postage-
prepaid and include the original cash register receipt (date and purchase price).
- Limitation of Liability -
It is expressly understood that Clam Corporation’s liability for its products, whether due to breach
of warranty, negligence, strict liability, or otherwise, is limited to the repair of the product as stated
above. Clam Corporation is not liable for any injury, loss, damage, or expense, whether direct or
consequential, including but not limited to loss of use, income, profit, or damage to material arising
in connection with the sale, installation, use of, inability to use, or the repair or replacement of
Clam Corporation products. Clam Corporation reserves the right to make alterations or
modifications in its products at any time, which in its opinion, may improve the performance and
efficiency of the product. It shall not be obligated to make such alterations or modifications to
products already in service.