Clarke CHT697 Installation guide

Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
Model Number: CHT697
Part Number: 1801697
BEARING RACE AND SEAL DRIVER SET
SAFETY
1. Familiarise yourself with the specific applications and limitations
of the driver, as well as any potential hazards.
2. Strike the driver squarely on the head - DO NOT hit the tool off
centre, or at an angle.
3. If unsure of the applications or limitations of the driver, contact
your supplier.
4. Ensure that the driver is the correct tool for the task. DO NOT use
the driver for any purpose other than that for which it is designed.
5. Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous
and will invalidate the warranty.
6. DO NOT use the driver if it is bent, chipped, has a mushroom
head, or is otherwise damaged as this may cause failure and/or
personal injury.
7. Ensure that the workpiece is stable and that there is adequate
lighting.
8. Maintain your correct balance and footing. Ensure the floor is not
slippery and wear non-slip shoes.
9. Use the correct size and type of hammer for the task. The
recommended diameter of the hammer face is 10 mm larger
than tool head. Check that the hammer handle is in good
condition and is secure in the hammer head.
NOTE: For seal installation a soft-faced hammer should be adequate and will be less likely to damage the
tool.
10. DO NOT strike the side of the driver body.
11. Make sure that the face of the hammer and the head of the tool
are clean and free from grease, oil, etc.
12. Position the tool so that it is struck away from your body.
13. DO NOT use the driver when you are tired or under the influence
of alcohol, drugs or intoxicating medication.
14. Keep children and unauthorised persons away from the working
area.
15. When not in use, pack into the case, and store in a safe, dry, childproof location.
WARNING: THE WARNINGS, CAUTIONS AND INSTRUCTIONS DISCUSSED IN THIS SHEET CANNOT COVER
ALL POSSIBLE CONDITIONS AND SITUATIONS THAT MAY OCCUR. IT MUST BE UNDERSTOOD THAT
COMMON SENSE AND CAUTION ARE FACTORS WHICH MUST BE APPLIED BY THE OPERATOR.
WARNING: ALWAYS WEAR APPROVED EYE PROTECTION WHEN USING THE DRIVER. FAILURE TO DO SO
MAY RESULT IN SERIOUS INJURY. NORMAL SPECTACLES ARE NOT ADEQUATE PROTECTION.

Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [email protected]
CONTENT
Check the contents and contact your Clarke dealer if any items are missing or damaged.
USAGE
1. Remove bolt (B) from handle (A).
2. Select the correct adaptor (C) and position it correctly on the
handle, securing it using the bolt (B).
• The adaptor should be one which is slightly smaller than the
diameter of the seal/bearing.
3. Place the seal/bearing race (E or F) in the mouth of the housing
(D).
4. Place the adaptor against the seal/bearing race and tap the
driver handle to force it into place.
1HANDLE
2ADAPTOR, 39.5mm
3ADAPTOR, 44.5mm
4ADAPTOR, 50mm
5ADAPTOR, 59mm
6ADAPTOR, 63mm
7ADAPTOR, 65mm
8ADAPTOR, 72mm
9ADAPTOR, 76mm
10 ADAPTOR, 81mm
WARNING: WE RECOMMEND THAT SAFETY GOGGLES ARE WORN WHEN USING THIS TOOL.