© 2018
Order #XXXXX
Connect ends
together, then
Tighten knob
to secure.
Corner
Completed Assembly
Item
1
2
3
4
5
6
7
8
Description
45”
Vertical Extrusion
45”
Vertical Extrusion
45”
Vertical Extrusion
45”
Vertical Extrusion
45”
Horizontal Extrusion
45”
Horizontal Extrusion
45”
Horizontal Extrusion
45”
Horizontal Extrusion
1
4
2
3
56
78
**
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab.Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
SEG Graphic Attachment
It is important to first insert
graphic into each alternate
corner, then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
Bolt
Foot
Attach Foot with Bolt.
SEG Extrusion
Foot Attachment
*
Connector
Straight
Slide connector into
horizontals, then tighten
knobs to secure.
Steps:
1) Connect horizontals [1-2] [3-4] [5-6] and [7-8] together. See Straight detail.
2) Connect assemblies together on floor. See Corner detail.
3) Attach foot to verticals [1] and [3]. See Foot Attachment detail.
4) Attach SEG graphic to front of assembled frame. See SEG Graphic Installation detail.
SETUP INSTRUCTIONS
If
you
would
like
to
tell
us
about
your
experience
with
your
setup
instructions
please
email
us
at
[email protected]VK-1903 Sunrise
