Clavis SECU S1000 User manual
Mounting instructions for double-bit high security
locks S1000
The lock is designed for use with a metal secure-storage unit and has to be mounted
using screws size 6, strength category 8.8. The tightening torque applied to tighten the
bolts must not exceed 10 Nm. Apply a liquid screws tightening agent to stop the screws
becoming loose. The lock can be mounted either horizontally, with the bolt pointing to
the left, or vertically, with the bolt pointing up or in as a left version (S1000-li) with the
bolt pointing to the right, or vertically, with the bolt pointing up.
The illustration above shows the lock dimensions.
There are two possibilities to release or operate the bolt mechanism of the lock:
1. Bolted-on bolt work mechanism: the bolt work mechanism is screwed to the
lock bolt using screws size M5. With this method, the bolt work is operated by
means of the lock.
2. The bolt work mechanism is not screwed on: With this method, the lock only
Allows the lock bolt to move freely. In other words, the bolt work is operated
separately.
Montageanleitung für S1000 EN Page 1 Date: 12/2015
sĞƌƚƌŝĞďĞŶĚƵƌĐŚ CLAVIS Deutschland GmbH
Grüner Weg 38
34117 Kassel
Telefon: +49 (0)561 988 499-0
E-Mail: [email protected]
Internet: www.tresore.eu
www.tresorschloss.de
- When mounting the lock, please take the necessary precautions, eg. by installing a
manganese plate, to make sure the lock is adequately protected against
forceful attack. We further recommend to secure the bolt work cover on the
back of the door with a small lock to prevent direct access to the lock whenever
the door is open.
- As a rule, the lock is opened clockwise and closed anti-clockwise.
- It is also possible to mount the locks so that the keys have to be entered from above or
below.
- After entering the key in the mounted lock, be careful not to put too much pressure on
the key from the side (risk of key breakage).
- Do not lubricate the lock with oil or grease.
- Prevent welding beads and similar dirt from getting into the lock.
Breakthroughs in doors:
Theschematicdiagramontheleftshowsthemaximumpermissible
dimensionsofthe through-holetobecutinthedoorforthe keyhole.
Theactual geometryoftheholehas to be arranged within the
contour shown.
Bolt strength:
Under normal conditions ofuse, the maximum permissible
forces acting onthe bolt in both directions (push and pull)
amount to 5 N. This force may be safely applied for at least
10,000 cycles.
The maximum forces on the bolt (acting in the opening direction)is 3 KN.
Montageanleitung für S1000 EN Page 2 Date: 12/2015
sĞƌƚƌŝĞďĞŶĚƵƌĐŚ CLAVIS Deutschland GmbH
Grüner Weg 38
34117 Kassel
Telefon: +49 (0)561 988 499-0
E-Mail: [email protected]
Internet: www.tresore.eu
www.tresorschloss.de
Table of contents
Other Clavis Lock manuals
