Clear One COLLABORATE Live 1000 User manual

COLLABORATE®Live 1000
Quick-Start Guide

COLLABORATE LIVE 1000
2
COMPONENTS INCLUDED
COLLABORATE Live 1000
COLLABORATE Live
codec with power supply,
COLLABORATE Remote
control with dongle, and
HDMI cable.
910-2100-003
UNITE 200 PTZ camera,
power supply, HDMI cable
and RS232 Serial Control
cable.
Note: The remote control
inside the camera box
is only for any advanced
configuration in the camera,
if required.
For the camera’s control, use
the COLLABORATE Codec
Appliance’s remote control.
CONVERGE Pro 2 48V
Mixer, BMA CT Ceiling
Tile Beamforming Mic
Array, cables and power
supplies.

QUICK-START GUIDE
3
MAKING THE CONNECTIONS
Connect the Ceiling Tile Beamforming Mic Array to the CONVERGE Pro
2 48V. Then, connect the CONVERGE Pro 2 48V, UNITE 200 camera,
Ethernet, and monitor(s) to the COLLABORATE Live codec as shown.
Ethernet Connection
CONVERGE Pro2 48V
1080p HDMI Camera Video
USB Audio Transmit and Receive
HDMI
Output
Display Port
Output
UNITE 200
PTZ Camera
Camera Serial Control
BMACT
P-Link PoE
E-bus from LINK Out

COLLABORATE LIVE 1000
4
CONNECTING THE REMOTE CONTROL DONGLE
The Remote Control includes a dongle that plugs into the FRONT USB
port on the codec.

QUICK-START GUIDE
5
CONFIGURING DISPLAY SETTINGS
After all peripherals are connected to the unit, turn the unit on.
Once COLLABORATE Live is loaded – you will see your local camera
video on your screen.
Using the remote control, navigate to the display settings:
Settings > Advanced > Display
According to your monitor capabilities, set to the maximum supported
resolution. If 2 monitors are connected to the unit, the display mode is
automatically changed to dual mode and you can set both monitors’
resolutions.

COLLABORATE LIVE 1000
6
CONFIGURING AUDIO SETTINGS
The COLLABORATE Live audio input and output is Converge Pro.
Verify this in COLLABORATE Settings > Audio & Video

QUICK-START GUIDE
7
CONFIGURING NETWORK SETTINGS
Using your remote control, navigate into the network settings:
Settings > Advanced > Network
The COLLABORATE Live obtains its IP automatically by default from the
DHCP server.
Set “Obtain Address From DHCP” to “Disabled” to manually configure
network settings.

COLLABORATE LIVE 1000
8
CLEARONE CONTACTS
© 2019 ClearOne, Inc. All rights reserved.
Information in this document is subject to change without notice. QSG-0079-001 Revision 1.0 February 2019
US & Canada
Tel: [phone]
TollFree: 800.945.7730
Fax: [phone]
TechSupport
Tel: [phone]
e-mail: [email protected]
Headquarters
5225 Wiley Post Way
Suite 500
Salt Lake City, UT 84116
Sales
Tel: [phone]
e-mail: [email protected]
International
Tel: [phone]
e-mail: [email protected]
Website
www.clearone.com