Clover OW1402 User manual

MONITOR
1. 50/60Hz system switch
Turn the switch on or off depends on the frequency of AC power source in your
area (60 Hz in U.S.A.).
2. V-Hold
Use to correct when the picture rolls up or down.
3. Brightness
Adjust brightness with this knob.
4. Contrast
Adjust contrast with this knob.
5. Mode select switch
Select CH1, CH2, or Automatic sequencing mode by pressing this switch
continuously.
6. CH1 indicator
This light is lit when CH2 has been selected.
7. CH2 indicator
This light is lit when CH2 has been selected.
8. Auto indicator
This light is lit when in the sequencing mode.
9. Dwell time
Sequencing time can be adjusted with this slider.
10. Audio volume slider
Use this volume control to adjust proper sound level from the cameras.
14 15 18 19 16
13
20 21 17
12
1234
6789
5 1 0 1 1

11. Power ON/OFF button
Turn the monitor ON/OFF.
12. Speaker
Audio out.
13. DC power input jack
Plug the DC 13V, 2A AC adapter (supplied) only.
14. CH1 input
Connect a camera to this input jack, which has 4-pin Din.
15. CH2 input
Connect a camera to this input jack, which has 4-pin Din.
16. Video output (RCA jack)
Video output port for VCR recording or slave monitor.
17. Audio output (RCA jack)
Audio output port for VCR recording or slave monitor.
18. Video1 in (BNC jack)
Connect a BNC type camera or video output of VCR to this port with a proper
cable (not included).
19. Video2 in (BNC jack)
Connect a BNC type camera or video output of VCR to this port with a proper
cable (not included).
20. Audio1 in (RCA jack)
Connect an audio output of VCR to this port with a proper cable (not included).
21. Audio2 in (RCA jack)
Connect an audio output of VCR to this port with a proper cable (not included).
PIN CONFIGURATION FOR 4-PIN DIN JACK

CAMERA
4
1
2
3
6
65
1. Lens
Adjust for the best picture by turning it clockwise or counter-clockwise.
2. Infrared LEDs
10 Infrared LEDs let you see objects in the darkness.
3. CDS sensor
Automatically turns the Infrared LEDs on/off as needed.
4. C-mic
High sensitivity condenser microphone.
5. 4-pin Din jack
Connect one end of the cable to this jack.
6. Tripod screws
INSTALLATION
1. Attach the mounting bracket to the desired location on the wall or ceiling,
wherever you want to install the camera. Locate a wall stud or ceiling joist and
secure the mounting bracket using the supplied screws.
2. Attach the camera to the mounting bracket and firmly tighten the swivel.

3. Connect the one end of cable (supplied) to the Din jack on the rear of the camera
and the other end of cable to the monitor. Make sure that two arrows on the top of
them should be aimed at each other.
Wall
(CAMERA)
(MONITOR)
MOUNTING
BRACKET
60’ cable
Wall Mount
(MONITOR)
CEILING
(CAMERA)
MOUNTING
BRACKET
60’ cable
Ceiling Mount