Coaster 103993 User manual

REVISION 0 : 12 /10/2012
PAGE 1 OF 4
103993
BENCH WITH WOODEN SEAT
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com

ASSEMBLY INSTRUCTIONS
PARTS IDENTIFICATION HARDWARE IDENTIFICATION
A 1 ALLEN WRENCH 1PC
B
C
5
D
6
7
8
9
www.coastercompany.com
TRESTLE BAR 2PCS
WOODEN SEAT
SCREW
2PCS
METAL RODS
METAL PLATE
8PCS
1PC
12PCS
4PCS
ITEM :
WOOD DOWEL
2BOLT
LOCK WASHER
2PCS
RIGHT LEG 2PCS
103993
PAGE 2 OF 4
NYLON WASHER
8PCS
FLAT WASHER
4PCS
2PCS
8PCS
3
4
LEFT LEG
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
!Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2. This product is for home use only and not intended for commercial establishment

ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
Place wooden seat upside down on a soft surface. Insert wood dowel to both end of trestle bar. Align &
Align and fasten left & right leg to wooden seat using fasten trestle bar to left and right leg using bolt & nylon
bolt, lock washer and flat washer. Tighten with Allen washer. Tighten with Allen wrench.
wrench.
STEP 3 STEP 4
Align & fasten left & right leg to wooden seat using Align & fasten trestle bar to left & right leg using bolt &
bolt, lock washer & flat washer. DO NOT TIGHTEN nylon washer. THEN TIGHTEN ALL THE BOLTS
AT THIS STEP. WITH ALLEN WRENCH.
www.coastercompany.com
ITEM :
PAGE 3 OF 4
103993

ASSEMBLY INSTRUCTIONS
STEP 5
Align & hook the metal rods to the metal plate. Align & fasten metal plate to the pre-marking at the bottom of the
wooden seat using screw (as per diagram shown). Tighten with screw driver ( NOT INCLUDED).
STEP 6
Complete
www.coastercompany.com
ITEM :
103993
PAGE 4 OF 4