Coaster 200701Q User manual

ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0 : 01/05/2009
REVISION 1 : 01/09/2012
PAGE 1 OF 4
www.coastercompany.com
REVISION 1 : 01/09/2012
200701Q (B1-B3)
QUEEN SIZE BED

ITEM : ASSEMBLY INSTRUCTIONS
A HEADBOARD
1PC E
BED SLAT
3PCS
FBED SLAT SUPPORT 3PCS
BLEFT HEADBOARD LEG 1PC WITH LEVELER
G
B1 (BOX 1) B3 (BOX 3)
PARTS IDENTIFICATION
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment.
G
CRIGHT HEADBOARD LEG 1PC
HB 1PC
D1PC
D
FOOTBOARD
1PC
Z - B3 (BOX 3)
1 BOLT 6PCS
3
SCREW 6PCS
2 ALLEN WRENCH 1PC
www.coastercompany.com
*FROM BOX 2
FOOTBOARD
*FROM BOX 1
HEADBOARD
COMPLETE
Z - B1 (BOX 1)
HARDWARE IDENTIFICATION
B2 (BOX 2)
www.coastercompany.com
PAGE 2 OF 4
200701Q (B1-B3)
2PCS
200701Q(B1)
200701Q(B2)
BED RAIL

ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
**BACK VIEW
**BACK VIEW
Place headboard panel upside down on soft surface,
place the headboard leg on the correct position
Align and fasten headboard leg to headboard panel using
bolt and tighten with Allen wrench.
**BACK VIEW
**BACK VIEW
www.coastercompany.com
IF PURCHASE HEADBOARD ONLY, SKIP BELOW STEPS
STEP 3
Align and hook the bed rails to headboard and footboard.
www.coastercompany.com
PAGE 3 OF 4
ITEM :
200701Q (B1-B3)
200701Q (B1) - BOX 1
200701Q (B1-B3) - BOX 1 to BOX 3

ASSEMBLY INSTRUCTIONS
Screw in the bed slat support to bed slat.
ITEM :
STEP 4
STEP 5 STEP 6
www.coastercompany.com
PAGE 4 OF 4
Align and fasten bed slats to bed rails using screw and
tighten with screw driver (Not included). Complete
PAGE 4 OF 4
200701Q (B1-B3)