Coaster 205135 User manual

PAGE 1 OF 4
205135
CHEST
www.coastercompany.com
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0: 04/19/2017

ASSEMBLY TIME
PARTS IDENTIFICATION
A
B
CHEST
LEG
1 PC
4 PCS
1
2
3
4
BOLT
LOCK WASHER
FLAT WASHER
ALLEN WRENCH
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast and easy assembly.
Warning!
1.Don't attempt to repair or modify parts that are broken or defective. Please contact the
store immediately.
2.This product is for home use only and not intended for commercial establishments.
ITEM:205135
PAGE 2 OF 4 www.coastercompany.com
15 MINUTES
ASSEMBLY INSTRUCTIONS
HARDWARE IDENTIFICATION
12PCS
12PCS
12PCS
1PC
NOTE: PHILLIPS HEAD SCREW DRIVER IS REQUIRED IN THE ASSEMBLY PROCESS;
HOWEVER, MANUFACTURER DOES NOT PROVIDE THIS ITEM

PAGE 3 OF 4
ITEM:205135 ASSEMBLY INSTRUCTIONS
STEP 1
www.coastercompany.com
STEP 3
COMPLETE
STEP 2
1
2
3
4
B
A

WALL
ANTI - TIPPING KIT
PARTS IDENTIFICATION
A CHEST 1 PC
HARDWARE IDENTIFICATION
5
6
CABLE TIE
8
7
9
PLASTIC ANCHOR
LONG SCREW
L - BRACKET
1 PC
2 PCS
SHORT SCREW
1 PC
1 PC
1 PC
1.1 Attach one of the mounting brackets securely to the back edge of the chest.Use the short screw.
1.2 Determine where the chest is to be placed and mark location on the wall for the mounting
bracket screw hole approximately 2"below the bracket mounted to the edge of the chest.
1.3 Drill a 3/16" hole in the wall. Press the plastic anchor into the hole and gently tap until the
flange on the anchor is against the wall surface.
1.4 Position the bracket over the anchor and use the long screw to securely attach the bracket
to the wall.
1.5 Place the chest so the bracket on the back edge is in line with the bracket on the wall.
1.6 Lace an end of the cable tie down through each bracket. Bring both ends together and slide
the beaded end of the cable tie through the keyhole shaped slot on the other end until snug.
Pull down on the beaded end until it snap locks into the keyhole slot.
1.7 To double lock return the beaded end back through the keyhole as shown.
1.8 Check to make sure the cable tie is securely laced and locked to the brackets.
5
9
6
8
7
A
PAGE 4 OF 4 www.coastercompany.com