Coaster 202085 User manual

202085
CHEST
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
REVISION 0 : 07/18/2011
PAGE 1 OF 3
www.coastercompany.com
REVISION 0 : 07/18/2011
REVISION 1 : 09/22/2011

ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
Unscrew the drawer pull from the back of drawer front with
screw driver (not included)
Align and fasten drawer pull to drawer front using screw and
tighten with screw driver (not included)
ITEM :
202085
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly.
Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishment
STEP 3
Complete
www.coastercompany.com
PAGE 2 OF 3

HARDWARE IDENTIFICATION
ACHEST 1SET 1SHORT SCREW 1PC
2LONG SCREW 1PC
3CABLE TIE 1PC
4L BRACKET 2PCS
STEP 1 STEP 2
PARTS IDENTIFICATION
ANTI-TIPPING KIT
STEP 3
www.coastercompany.com
PAGE 3 OF 3
Attach a L-bracket securely to the back top rail of
the chest using short screw provided, through the
smaller hole.
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of chest. Attached to
the wall stud using the long screw provided,
through the smaller hole.
Place the chest into position so both L-brackets are vertically in line. Insert the end of the cable tie
through the larger hole in each L-bracket. Bring both ends together and slide the flat end through the
locking end and pull until tight.