Coaster 600174 User manual

REVISION 0: 09/25/2013
600174
ROCKING CHAIR
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
www.coastercompany.com
PAGE 1 OF 4

ITEM :
ASSEMBLY INSTRUCTIONS
A
CHAIR BACK
1PC
F
WOODEN SEAT 1PC
B
1PC
G
1PC
C
1PC
H
1PC
D
LEFT LEG FRAME
1PC
E
RIGHT LEG FRAME 1PC
1
LONG BOLT
8PCS
6
1PC
2
SHORT BOLT
9PCS
7
BARREL NUT
6PCS
3
LOCK WASHER
17PCS
8
WOOD PLUG
9PCS
4
2PCS
5
15PCS
www.coastercompany.com
600174
PARTS IDENTIFICATION
LEFT ARM
REST
BACK STRETCHER
FRONT STRETCHER
HARDWARE IDENTIFICATION
SMALL FLAT
WASHER
PAGE 2 OF 4
ALLEN WRENCH
BIG FLAT
WASHER
RIGHT ARM
REST
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instruction in the same sequence as numbered to assure fast & easy
assembly.
!Warning!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact
the store immediately.
2. This product is for home use only and not intended for commercial establishment.

ITEM :
ASSEMBLY INSTRUCTIONS
STEP 1 STEP 2
STEP 3
www.coastercompany.com
PAGE 3 OF 4
600174
Align and fasten front and back stretchers to left and
right leg frame using barrel nut, long bolt, lock washer
and small flat washer and tighten with Allen wrench.
Insert wood plug into the open holes of leg frame.
Place wooden seat upside down on soft surface.
Align and fasten left and right leg frame to
wooden seat using short bolt , lock washer and
small flat washer and tighten with Allen wrench.
Align and fasten chair back to wooden seat using short bolt, lock washer and small flat washer and tighten
with Allen wrench. Insert wood plug into the open holes of chair back brace.

ITEM :
ASSEMBLY INSTRUCTIONS
STEP 4
STEP 5
Complete.
www.coastercompany.com
600174
4.1) Align and fasten left and right arm rest to wooden seat using long bolt, lock washer and big flat washer.DO NOT
FULLY TIGHTEN AT THIS STEP.
PAGE 4 OF 4
4.2) Align and fasten left and right arm rest to chair back using long bolt, lock washer and small flat washer.
THEN FULLY TIGHTEN ALL THE BOLTS AT STEP 4.1 & 4.2 WITH ALLEN WRENCH. Insert wood plug into the
open holes of chair back.
4.2
4.1