Coaster Jessica 200712 User manual

200712
Nightstand
ASSEMBLY INSTRUCTIONS
COASTER FINE FURNITURE
Fine Furniture for every stage of life
PAGE 1 OF 4 COASTERFURNITURE.COM
REVISION 0 : 05/14/2008
REVISION 1 : 12/04/2012
REVISION 2 : 08/08/2017
REVISION 3 : 09/11/2018
REVISION 4 : 12/02/2019

A
PARTS IDENTIFICATION
10 MINUTES
ASSEMBLY TIME
1PC
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.
NOTE:
ASSEMBLY TIPS:
WARNING!
1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishments.
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
NIGHTSTAND
A
STEP 1
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ITEM:200712
COASTERFURNITURE.COM
PAGE 2 OF 4

STEP 2
COMPLETE
ASSEMBLY INSTRUCTIONS
COASTERFURNITURE.COM
PAGE 3 OF 4
ITEM:200712

ANTI-TIPPING INSTALLMENT INSTRUCTIONS
FURNITURE TIPPING RESTRAINT
Injury may result from tipping furniture.
WARNING
This restraint may protect against tipping furniture.
Do not allow children to climb on furniture.
This restraint is not a substitute for proper adult supervision.
Failure to detach this restraint before moving the furniture may result in injury and damage.
This tip restraint must be attached to a wall stud
using long screw enclosed.
STEP 1
Attach a bracket securely to the back top rail of the
furniture using short screw provided, through the smaller
hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of furniture. Attach the wall
stud using the long screw provided, through the
smaller hole.
STEP 3
Place the furniture into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the large hole in each mounting bracket. Bring both ends together and slide the
flat end through the locking end and draw it through until all slack is removed.
Confirm that the strap is securely laced and locked.
COASTERFURNITURE.COM
PAGE 4 OF 4
ITEM:200712

COASTERFURNITURE.COM
ITEM:200712
15.1"
26"
23"
NOTE : DIMENSION TOLERANCE ±5%
2.6"
21.5"
7.9"
2.4"
13.1"
INNER SIZE OF DRAWER A : 5.6" x 12.8" x 19.1"