Coleman Tent 9273-012 User manual

Connect Frame to Tent
–Insert the pin into the ends of the top main
tent pole at the rear of the tent.
(illus. 3, illus. 4)
–Go to opposite end of pole and gradually
apply pressure to the pole forming an arch
until you are able to insert the pin into the
pole end. (works best standing in the door,
with two people) Repeat for second pole.
–Insert the pin on the side into the side to side
main pole end. Go to opposite end of pole
and gradually apply pressure to the pole
forming an arch until you are able to insert
the pin into the pole end. Repeat for second
pole. (illus. 3, illus. 4)
TIOGA™6 12’x12’
1Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent, using the rings on the
stake loops. Keep the floor taut. (illus. 2)
–Assemble frame poles by interlocking
shock-corded poles. (four poles)
–Insert the main tent poles through the two
pole sleeves that go side to side, parallel
to the front of the tent. (illus. 1)
–Insert two main poles through the pole
sleeves running the opposite direction.
these poles should be on top of the first
two poles where they cross.
2
When You Are Ready To Set
Up Your Tent
–Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
Rainfly
Poles
Front Door
Poles to be on top
Assembled black main tent poles inserted through
pole sleeves in both directions.
Instructions apply to Part Number 9273-012
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9273-3421
Part No. 9273-3481
Main Tent
Pole
illus.3
Insert pin into pole end
Rainfly Part No. 9273-3461
Side to side
poles

THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA Rev. 11/05
Things You Should Know
• Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
• STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
• TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
• Seam sealer has not been provided with your tent. For additional
protection we recommend seam sealing your tent prior to camping. Seam
sealer may be purchased through your local retailer or at your local sporting
goods store.
• Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammabili-
ty requirements of CPAI-84. The fabric will burn if left in continuous
contact with any flame source. The application of any foreign sub-
stance to the tent fabric may render the flame-resistant properties
ineffective.
Attach Tent to Frame
Using Frame Clips
–Attach frame clips along
the edges of tent to frame poles.
(illus. 5), (illus. 6)
–Make any adjustments to the tent
corner stakes that are needed.
3
4Attach Rainfly
–Assemble rainfly poles by
interlocking shock-corded poles.
–Insert rainfly poles through pole
sleeves located at the center of the
curved edges of the underside of
rainfly. (illus. 7), (illus. 9)
–Drape rainfly over tent frame, pole
side down. Rainfly poles should
be over door, rear and sides of tent.
–Connect the eight elastic loops with
hooks, (found at the rainfly
corners) to the eight fabric loops on
the bottom row of frame clips.
(illus. 8), (illus. 9)
–Insert the tips of the rainfly poles
into the grommets on the frame clip
webbing. (See above illus. 6)
–Secure rainfly with attachments
located on underside of fly. (illus. 8)
illus. 6
Assembled tent without rainfly.
NOTE:
Grommets
for rainfly
pole are on
frame clip
webbing illus. 5
Frame clips
illus. 7 Insert rainfly
poles through the
4 pole sleeves on
underside of rainfly
illus. 9
Completed tent with rainfly.
illus. 8
Underside of
rainfly attaches
to frame poles
Rainfly pole in
grommet
Rainfly hooks attach to fabric loops
on the corner frame clips (illus. 8)
Rainfly poles
through
pole sleeves
Hooks attaches
to fabric loop