COLORATO CLB-100BDC User manual

www.colorato.net
INSTRUCTION MANUAL
OF COMMERCIAL BLENDER
WITH ELECTRONIC CONTROL BOARD
MODEL: CLB-1 BDC
Read carefully these instructions before using the appliance and
save them for future reference

1
Contents
COLORATO recommends safety first ………………………………………………... 2
Important safeguards for your Blender ……………………………………………….
2
Important safeguards for all electrical appliances …………………..…………….. 3
Characteristics …………………………………………………………………………….
Technical parameters ……………………………………………………………...….…
4
5
Exploded view for spare parts ………………………………………………………….
6
Control panel ……………………………………………………………………………… 8
How to use the Blender……………………..….……………………………………….. 1
Function Program Sheet ………………………………………………..………………. 11
Install, Take Apart The Safety Mute Cover …………………………………………...
12
Disassembling your blender for cleaning, care and storage …………………….. 13
Easy trouble shooting ……………………………………….......................................
Guarantee & service…...…………………………………………………………………
14
14
Recipes …………………………………………………………………………………….. 15

2
COLORATO recommends safety first
We at COLORATO are very safety conscious. We design and manufacture
consumer products with the safety of you, our valued customer, foremost in
mind. n addition, we ask that you exercise a degree of care when using any
electrical appliance and adhere to the following precautions:
Important safeguards for your Blender
♦ Carefully read all instructions before
operation and save for future reference.
♦ Remove any packaging material and
promotional stickers before using the
Blender for the first time.
♦ Make sure that the indicated voltage is the
same as the local voltage.
♦ Do not place the blender near the edge of
a bench or table during operation. Ensure
that surface is level, clean and free of
water, flour etc. Vibration during operation
may cause the appliance to move.
♦ Do not place this appliance on or near a
hot gas or electric burner, or where it could
touch a heated oven.
♦ Always ensure the blender is properly
assembled before use.
♦ Do not use any other accessories or
components that are not from our
manufacturer, in order to avoid damage.
♦ Do not remove any accessories from the
product when the power is on.
♦ Do not leave the blender unattended while
in use.
♦ f the blade is stuck, pull out the plug and
clean the food stuck in the blade.
♦ Wait until the blade has completely
stopped spinning before removing the
cover or the mixing cup.
♦ Do not use this product on carpet, cloth,
thin paper that might block the air outlet
which can affect the heat dissipation.
♦ Do not soak the device in any liquid. Clean
it by wet cloth only.
♦ Never place your fingers or utensils inside
the Blender cup without unplugging the
unit from the power outlet.
♦ Do not touch the sharp blade especially
when the plug is on. Danger of injury.
♦ Keep hands and utensils out of the mixing
cup while the motor is running, to prevent
the possibility of severe personal injury
and/ or damage to the blender. A rubber
scrapper may be used, only when the
machine is not running.
♦ To protect against electric shock do not
immerse the base, the motor, the plug or
the cord in water or any other liquid.
♦ Do not use the blender for anything other
than mixing liquids or food.
♦ Use a soft piece of cloth in order to clean
the display’s surface.
♦ Always keep the device clean.
♦ f there is any damage on the plug or
components of the device, please stop
using this product, contact manufacturer or
professional to change it.
♦ Do not remove the accessories of the
device when it is in use.
♦ n case of food overflows, the liquid in the
mixing cup can not exceed 2lit (especially
in high speed processing), when
processing high temperature liquid or the
mixed food does not exceed from 1,5 lit of
the mixing cup.
♦ Do not allow people with physical or
mental incapability, or people that are not
familiar with these types of products to use
the blender.
♦ After using the blender, pull out the plug
immediately and clean it.

3
mportant safeguards for all electrical appliances
♦ Fully unwind the cord before use.
♦ To protect against electric shock, do not
immerse cord, plug or motor base in water
or any other liquid.
♦ Do not let the cord hand over the edge of a
table or counter, touch hot surfaces or
become knotted.
♦ This appliance is not intended for use by
young children or infirm persons unless
they have been adequately supervised by a
responsible person to ensure they can use
the appliance safely.
♦ Young children should be supervised to
ensure that they do not play with the
appliance.
♦ t is recommended to regularly inspect the
appliance. Do not use the appliance if the
power supply cord, plug or appliance
becomes damaged in any way. Return the
entire appliance to the nearest authorized
COLORATO Service Centre for
examination and / or repair.
♦ Any maintenance other than cleaning
should be performed at a COLORATO
authorized Service Centre.
♦ This appliance is for professional use. Do
not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats. Do not use outdoors.
The symbol on the product means that at the end of its life, the appliance has not to be
considered a common waste. t is a special waste and has to be demolished in specific
recovery and disposal area, as prescribed by the EC Directive 2002/96/EC (WEEE). By
disposing this product correctly, you can avoid negative consequences for the environment
and for the human health, due to the presence of potentially dangerous substances in the
product.
Attention

4
Characteristics
The blender CLB-100BDC is a new generation professional blender. Except for the traditional
functions such as high revolving speed, low revolving speed and pulse, the COLORATO
Blender also uses an intelligent program for different needs. We have developed functions for
stirring, food processing, mixing and paste fruits, with four kinds of programs, so that the
mixtures that are being produced fully complete your demands.
• t has a high speed brushless DC motor, without brushess, with long life, three times
than the usual motors.
• t is ideal for crushing ice, melting fruits, vegetables, preparation of smoothies,
milkshakes, water ice etc.
• t is being controlled by micro-computer. Each programme is working in different
speed, making uniform, quick and easy mixing of the ingredients.
• 3D professional stainless steel blades.
• 2L Makrolon (PC) mixing cup with scale, thermostability, solid and unbreakable.
• mport double stainless steel ball bearing, life time more than 5 times of the normal
bearings, also preventing from water inflow or leaking.
• Aloof drawing shell, gorgeous out looking.
• Easy cleaning/maintenance. All the accessories of the jug are easily disassembled
and washed (including the knife)
• Silent motor, without shaking, with a special safety mute cover.
• deal for commercial use in cafes, bars, hotels, commercial kitchens, fast foods etc.

5
Technical parameters
Model CLB-100BDC
Voltage 220-240V-/50Hz
Capacity of the mixing cup 2000ml
Durability of the mixing cup -20ºC~120º
Motor Power 1000 W
Noise level 74 db
Net weight 7.2 kg
Blade 1.5 mm, stainless steel
Cord’s length 1.8 M
Dimensions 224x288x508mm (WxDxH)
Protector Safety protector,
Motor thermal protection
Max speed: 15000r/min

6
Exploded view for spare parts

7
1 Shock absorber 28
Power cord
2 Coupling 29
Plus screw
3 Top panel 30
Cable clamp
4 Gasket 31
Muddler
5 Gasket 32
Safety mute cover
6 Plus screw 33
Hinge B1
7 Cover 34
Hinge B2
8 Label 35
Hinge A2
9 Logo 36
Hinge A1
10 LCD screen 37
Safety mute cover
11 Control panel 38
Shock absorbe
12 Plus screw 39
Bracket Panel
13 Bracket 40
Connector
14 PCB 41
Plus screw
15 EMC board 42
Plug
16 Base 43
Nut
17 Nylon bushes 44
Plus screw
18 Gasket 45
Measuring cup
19 Plus screw 46
Cup cover
20 Gasket 47
Nut
21 Fixer 48
Gasket
22 Gasket 49
Blade
23 Motor module 50
Blade holder
24 Gasket 51
Seal ring
25 Fan 52
Mixing cup
26 Gasket 53
Seal ring
27 Nut 54
Nut

8
Control Panel
Name Icon Function description Running
time
Power switch
Red light on when plugged in,
flashing circle means the unit
is in but status is off, in this
time, other buttons will not
work. Push the power switch
will turn the status to standby;
in standby status other
buttons will work normally.
Stir button
Press this button, the unit will
work as the written program,
this function will cut food to
thin drinking, such as: orange
juice, ice water.
15’’
Food process
button
Press this button, the unit will
work as the written program,
this function will cut food
material quickly, it is able to
process thick ice and hard
salad materials.
31’’
Mixing button
Press this button, the unit will
work as the written program,
this function will mix 2 or
more food materials equally,
35’’

9
such as cocktail and
mayonnaise.
Fruit paste button
Press this button, the unit will
work as the written program,
this function will process food
material to dense liquid such
as ketchup, salad dressing
and banana milkshake.
78’’
High speed button
Press this button, the motor
will run in high speed and the
speed will not change when it
is running.
180’’
Low speed button
Press this button, the motor
will run in low speed and the
speed will not change when it
is running.
180’’
Pulse button
Press this button, the motor
will run in the highest speed,
motor will stop running while
releasing this button. This
function is able to cut big hard
ice into snowflakes in 5
seconds and also process
food material at any time.
30’’
(continuous
pressing)
LCD timer
The timer shows the time of
high speed, low speed and
pulse. t also shows the
program numbers of mixing,
fruit paste, stir and food
process functions.