Powersports Winch
Model: Cub 4
PN: 123920 12V DC 123932 12V DC
123925 12V DC
Introduction
Feature
Line pull: 1,814 kg / 4,000 lb wire rope first layer
Wire rope: 5.5 mm x 15.2 m (7/32" x 50') galvanized aircraft A7 × 19
Brake: Mechanical spring applied and permanent magnet motor
dynamic brakes together
Clutch: Turn the shifter for rapid wire rope payout
Control: Handlebar rocker switch powers the winch
Unpacking
．Winch assembly…………………………………………………….. 1 pc
．Handlebar rocker switch kit………………………………………… 1 pc
．4 way roller fairlead…………………………………………………. 1 pc
．Wire rope with safety hook…………………………………………. 1 pc
．Contactor pack ………………………………………………….……1 pc
Read this manual carefully
You should carefully read and understand this manual before operating it.
Careless winch operation may result in personal injury hazards or property
damage.
Information requesting or parts ordering
Please specify the followings information:
．Winch PN ．Serial number
．Part description ．Replacement part number
．Quantity for each part
Installation
Before using the winch, make sure all electrical
components have no corrosion or damaged; the
environment should be clear and dry.
Wire rope replacement
．It is very important that the winch will be mounted on
a flat and hard surface of mounting channel in order to make sure the
motor, drum and gearbox housing are aligned correctly.
．Roller fairlead does not mount to winch directly.
．The wire rope shall be wound in an under-wound orientation only.
．Four (4) M8 x 25L 8.8 grade high tensile steel bolts must be used in order
to sustain the loads imposed on the winch mounting.
．Two (2) M8 x 20L 8.8 grade high tensile steel bolts must be used for
fastening the roller fairlead into the mounting channel.
Wiring Diagram
Attach the black lead firmly to the negative (–)battery terminal and red lead
to the positive (+) battery terminal. The voltage drop for the winch motor
must not exceed 10% of the nominal voltage of 12V DC.
Nut fastening for motor & contactor
1.Holding the lower nut on the stub and fastening the upper nut clockwise.
2.The torque setting for nut is 5.7 N-m / 50 lb-in.
Warning
．The winch is not intended to be used in any manner for the movement or
lifting of personnel.
．The pulling capacity shown is based on the first layer of rope on the drum.
．The rope winding on the drum shall remain 5 wraps from the drum.
