comfortel ANTONIO 8675 User manual

comfortel.com.au
#8675 ANTONIO
antonio
salon mirror
owners manual
GET STARTED
ANTONIO
Steel Salon Workstation
Width: 650mm Height: 1400mm Depth: 303mm
Weight: 23.3Kg
Material: Metal frame, MDF & glass bench

All measurements are in MM.
ASSEMBLY
ASSEMBLY
1. Position Bench into frame so screw holes meet.
2. Tighten each screw into each hole on both left and
right side, ready for mounting.
GENERAL SAFETY
1. Read carefully and keep these instructions
in a safe place.
2. Use this product only for its intended
function and do not use attachments not
recommended by the manufacturer.
3. Do not use outdoors.
IMPORTANT PLEASE READ THESE SAFETY INSTRUCTIONS
WEIGHT:23.5kg
PLEASE USE CORRECT FIXTURES FOR MOUNTING BASED ON WALL TYPE. NO RESPONSIBILITY
IS ACCEPTED FOR ANY DAMAGE OR INJURY CAUSED BY INCORRECT MOUNTING.
WALL FIXINGS NOT SUPPLIED. PLEASE REFER
TO MIRROR WEIGHT WHEN INSTALLING TO
DETERMINE BEST PRACTICE MOUNTING.
WALL STUDS AND NOGGINS ARE NOT
REQUIRED WHEN INSTALLING MIRRORS
IMPORTANT

PLEASE USE CORRECT FIXTURES FOR MOUNTING BASED ON WALL TYPE. NO RESPONSIBILITY
IS ACCEPTED FOR ANY DAMAGE OR INJURY CAUSED BY INCORRECT MOUNTING.
BEFORE INSTALLING YOU SHOULD CONSIDER THE FOLLOWING:
Allow for the necessary room around the unit for free movement. If applicable, when installing a bench, position it
so it is 800 - 850mm from the floor. This is the recommended bench height. Install mirror above bench to desired
height according to the bench and bench height.
POSITION
Footprint : Floor View
POSITION
Wall Back
SIDEBACK
All measurements are in MM.
Bench Height:
850mm
2000
570
2040
INSTALLATION: RECOMMENDED WALL MOUNTING
A

The information contained in this document is subject to change without notice and
should not be construed as a commitment by Comfortel Furniture Pty Ltd.
Comfortel Furniture Pty Ltd. assumes no responsibility for any errors that may appear in
this document nor does it make expressed or implied warranty of any kind with regard
to this material, including, but not limited to, the implied warranties of merchantability
and fitness for a particular purpose.
Comfortel Furniture Pty Ltd. shall not be liable for incidental or consequential damages
in connection with or arising out of the use of this document and the program material.
PRODUCT CODE
PURCHASE DATE INVOICE NUMBER
NOTE YOUR PURCHASE DATE & INVOICE NUMBER FOR FUTURE REFERENCE
#8615 ANTONIO SALON MIRROR
Revision Date: 12.06.2018
A periodic inspection of all components and fasteners
should be made to ensure that your Comfortel
product is structurally intact and functioning properly.
Damaged and broken parts should be replaced and
loose fasteners tightened.
All maintenance to be carried out by a suitably
qualified tradesperson.
GENERAL CLEANING
·We recommend the use of soapy water or
approved cleaners.
·This product should not be cleaned with abrasive
materials.
·Damage caused by any improper treatment is not
covered by the product warranty
MAINTENANCE
CLEANING
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE
For more information about our products and services, contact us at comfortel.com.au
comfortel.com.au
©Comfortel Furniture 1997-2018. All rights are reserved.
No part of this document may be photocopied,
reproduced or translated to another language without
written consent of Comfortel Furniture Pty Ltd.
PERIOD AND DESCRIPTION PRODUCTS
12 MONTHS PARTS & LABOR All products
2 YEARS PARTS ONLY All products excluding small electrical appliances
3 YEARS PARTS ONLY Linak electric actuators
5 YEARS PARTS ONLY Taps cartridge, ceramic basins
TERMS AND CONDITIONS
For more information about our warranty, please contact us at comfortel.com.au.
WARRANTY PERIOD