Command Center SRM User manual

SRM Data Collection Guide
If you encounter any diculties, or have any
questions, please contact us at:
[phone] or [email protected]

Data Collection Using
the Direct Method:
• Turn on the SRM, conrm battery power by observing
LED.
• Connect a sensor.
• Open the COMMAND Center App, or search for
“COMMAND Center Concrete” in the App Store to
install the app on your iOS device.
• Make sure Bluetooth is turned on for your device.
• Open or create a new project le in the app. Opening
the project le initiates communications between the
SRM and the app.
• If it is the rst time the sensor is introduced to the
project le, you will be asked to ‘add new sensor?’ to
your project.
• Tap ‘Add to Project,’ and the sensor details screen
appears automatically. Enter optional inputs and
adjust placement date and time. Tap ‘done’ to add.
Note: Tap the sensor’s name or serial number
to access the ‘sensor details’ screen at any time
to adjust inputs after the sensor is added to the
project.
• Disconnect the sensor after it is introduced and close
the project le. Repeat this process for each sensor
to be added to the project le.
• If the connected sensor is already present in
the project le, new data will be added when
communicating with the SRM. The date and time of
most recent data point will update. You can connect
multiple sensors at once when adding new data to
sensors that already exist in the project le.
• The Bluetooth icon will appear next to the sensor
that is updating. If multiple sensors are connected at
once, the icon will appear next to each sensor as it
updates.
• Once the last sensor connected updates, close the
app and disconnect sensors.

If you encounter any diculties, or have any
questions, please contact us at:
[phone] or [email protected]
Data Collection Using
the Indirect Method:
• Do NOT use this method to introduce sensors for
the rst time into a project le unless you are only
adding one sensor.
• Turn on SRM, connect sensor(s), and press ‘save’
button once.
• LED will ash green for each sensor successfully
downloaded and red when a sensor download fails.
• Once the LED stops ashing, disconnect sensors.
Viewing the Data Charts:
• Tap the circle next to each sensor to include in chart.
• Tap ‘chart’ to view the selected sensors.
• Select chart type from the tabs above the chart.
• Tap a point on the chart to view details.
• Tap a goal indicator to see goal information.
• Pinch screen to zoom, tap and move to pan.
Sharing Data via Email:
• Open a project le and tap ‘share.’
• Choose the type of report or choose to share the
entire project le. The iOS share dialogue will open.

www.COMMANDCenterConcrete.com
FAQ and Troubleshooting
I downloaded the sensor data but cannot
see any data on the graph.
The chart will only display sensor data after the
selected placement date and time. Check that the
placement date and time are correct.
App is not connecting to SRM within 10
seconds of opening the project le.
First conrm the following;
1. SRM has sucient battery power. Check the
battery on the SRM by cycling the ON/OFF
switch. LED will blink three times: green=good,
yellow=low, red=replace.
2. SRM has at least one sensor connected properly
and is in range of iOS device (within 30 feet).
3. Bluetooth is enabled on your iOS device and your
device is not currently connected to another
Bluetooth device (headset, speaker, etc.).
4. A Project File is open.
If App still fails to connect:
1. Force close and reopen the COMMAND Center
App.
2. If necessary, reboot the iOS device and/or SRM.
!
Tap our help topics on the top right of software
screens for basic explanations of the software
functions.