CommScope CMAX-OUS-43-i53 User manual

M0149AKA_InstInstr_CMAX-OUS-43-i53
Technical Support:
http://www.commscope.com/wisupport
INSTALLATION INSTRUCTION FOR
CMAX-OUS-43-i53
Installation Mode 1
Installation Steps
1) Cut a hole on ceiling with the diameter shown in the left picture.
2) Remove the retaining nut from the back of the antenna.
3) Feed the pigtail of the antenna through the hole.
4) Re-install the retaining nut so that it is close-fitting to the ceiling.

M0149AKA_InstInstr_CMAX-OUS-43-i53
Andrew Wireless Systems GmbH
Industriering 10 * 86675 Buchdorf * Germany * Phone: [phone]
E-mail: W[email protected] * http://www.commscope.com
Installation Mode 2
Installation Steps
1) Drill 4 holes on ceiling per the pattern of holes which shown in
the right chart above.
2) Insert the plastic plug into the holes.
3) Remove the retaining nut from the back of the antenna.
4) Fix the antenna to the ceiling by using the tapping screws
(ST4.2X25).
© Copyright 2019 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or
faults.
CommScope reserves the right to change all hardware and software characteristics without notice.
Names of products mentioned herein are used for identification purposes only and may be trademarks and / or registered
trademarks of their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means,
electronical, mechanical photocopying, recording or otherwise, without prior written permission of the publisher.
CommScope, 07-March-2019