CommScope CMAX-OMF3-43-UWI53 User manual

M0149AGB_InstIns tr_CMAX-OMF 3-Antennas
Technical Support:
http://w ww .com m scope.com /w is u pp ort
INSTALLATION INSTRUCTION FOR
CMAX-OMF3-43-UWI53 AND CMAX-OMF3-UWI53
Note
1) Cable min. bending radius: 40mm
2)
For massive/hard ceilings, please use
Hard Ceiling Mounting Kit 7705125
which serves to guide the jumper to the
side. For this kit, a separate instruction
(M0149AWx) is available:
Installation Steps
1)
Cut a hole in the ceiling tile
with the diameter shown in the
left picture.
2)
Remove the retaining nut from
the back of the antenna.
3)
Feed these two
pigtails of this
antenna through the hole in
the ceiling tile.
4)
Re-install the retaining nut so
that it is close-
f itting to the
ceiling tile.
1)
Drill two holes in the ceiling per
pattern of holes in this antenna
shown in the left.
2) Fasten the flat side
of this
anchors (Plastic plug
∅
6X25mm) and screws
(Tapp
ing Screw ST4.2X25mm).
3)
Mount this antenna to the
ceiling tile.
Tapping Screw ST4.2X25

M0149AGB_InstIns tr_CMAX-OMF 3-Antennas
Technical Support:
http://w ww .com m scope.com /w is u pp ort
© Copyr ig ht 2020 CommScope, Inc.
All r ig hts r eser ved.
All information contained in thi s manual has been r evised thoroug hly. Yet CommScope accepts no liability for any om issions or
faults.
CommScope reser ves the right to chang e all har dware and software characteristics without notice.
Names of pr oducts mentioned herein are used for identifi cati on pur poses only and m ay be trademarks and / or reg istered
tr adem ar ks of their respective companies.
No parts of this publ ication may be r epr oduced, stored in a retr ieval system , transmitted in any form or by any means,
electr onical, mechanical photocopying , r ecor di ng or otherwise, without pr ior written per mission of the publisher.
CommScope, 04-May-2020