CommScope CMAX-OMF8-43-UWI53 User manual

M 0149AXA_InstIn str _CM A X-OMF8-43-UWi53
Technical Support:
http://w ww .com ms cope.com /w isu pp or t
INSTALLATION INSTRUCTION FOR
CMAX-OMF8-43-UWI53
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna.
3) Feed the pigtails of the antenna through the hole in the ceiling tile.
4) Re-installthe retaining nut so that it is close-fitting to the ceiling tile.

M 0149AXA_InstIn str _CM A X-OMF8-43-UWi53
Technical Support:
http://w ww .com ms cope.com /w isu pp or t
Note
1) Cable min. bending radius: 40mm
2)
For massive/hard ceilings, please
use Hard Ceiling Mounting Kit
7705125 which serves to guide the
jumper to the side. For this kit, a
separate instruction (M0149AWx) is
available:
© Copyr ig ht 2020 CommScope, Inc.
All rights r eser ved.
All information contained in this m anual has been r evi sed thoroug hly. Yet CommScope accepts no liabil ity for any omissions or
faults.
Comm Scope reserves the right to chang e all har dware and softw are characteristics without notice.
Names of products mentioned herein are used for identificati on pur poses only and may be trademarks and / or registered
tr ademarks of their r espective com panies.
No parts of this publication m ay be reproduced, stored in a retr ieval system, tr ansm itted in any for m or by any m eans,
electronical , mechanical photocopying , r ecor ding or otherwise, without prior written permission of the publisher.
Comm Scope, 04-May-2020