CommScope CMAX-O-CPUSEWV53 User manual

Installation instruction CMAX-O-CPUSEWV53
Page 1 M0149ABB_Installation_CMAX-O-CPUSEWV53-Antenna
Installation Of CMAX-O-CPUSEWV53 Antenna
Note: Please read the complete description before starting the installation. Make sure that
connectors are properly sealed against water if no cables are connected to them after
installation.
Installation without the Ceiling Mount kit:
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna (labeled tight part for connector
in the diagram above).
3) Feed the pigtail of the antenna through the hole in the ceiling tile.
4) Re-install the retaining nut so that it is snug against the ceiling tile.
18mm/0.7in

Installation Instruction for CMAX Antennas
Page 2 M0149ABB_Installation_CMAX-O-CPUSEWV53-Antenna
Installation with the Ceiling Mount kit, part number: 7760591:
Description:
Through Omni antenna mounting kit conceals the antenna with only the nose protruding
through the ceiling. The base plate is hidden above the false ceiling which results in a 50%
reduction of the visible antenna footprint.
Installation Steps:
1. Cut a hole with a diameter of
∅
123mm/4.84in into the ceiling where
the antenna is supposed to be
installed.
2. Screw trim holder and upper holder
together through the hole in the ceiling.
Ceiling thickness
12-24mm/0.47-0.94in
Environmental conditions
Indoor
Weight
152g
ROHS
Compliant
∅155mm/∅6.1in
40mm/1.57in
Limit Position
∅123mm/4.84in
Locking Ring
Trim Holder
Upper Holder Ring

Installation Instruction for CMAX Antennas
M0149ABB_Installation_CMAX-O-CPUSEWV53-Antenna
Technical Support:
http://www.commscope.com/wisupport
3. Adjust the locking ring to fasten the
antenna mount to the ceiling.
4. Remove the four films on the surface of
the mounting tape.
5. Attach the radome to the upper holder
as outlined to the left.
Version
Changes
Release Date
M0149ABA
15-November-2016
M0149ABB
- part number for ceiling mount kit added
22-November-2016
© Copyright 2016 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or faults.
CommScope reserves the right to change all hardware and software characteristics without notice.
Names of products mentioned herein are used for identification purposes only and may be trademarks and / or registered trademarks of
their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means, electronical,
mechanical photocopying, recording or otherwise, without prior written permission of the publisher.
CommScope, 22-November-2016
Locking Ring
Mounting Tape