Comnet CNFE100-A User manual

INS_CNFE100(X)-A_REV–
06/21/11
PAGE 1
INSTALLATION AND OPERATION MANUAL
CNFE100(X)-A
10/100 MBPS ETHERNET MEDIA CONVERTER
FOR AIGIS DOME
The series of Ethernet media converters are designed to transmit and receive 10/100
Mbps data over one multimode or single mode optical fiber. They are designed to be
mounted within an Aigis dome and provide optical Ethernet output.
The electrical interface will Auto-Negotiate to a 10 Mbps, or 100 Mbps Ethernet rate
without any adjustments. The optical interface operates at a 100 Mbps Ethernet rate.
The series is environmentally hardened to operate in extreme temperatures.
An LED indicator confirms equipment operating status. Figure 6 on Page 4 describes
the LED indicators for the unit.
The CNFE100(X)-A series media converters are designed to be mounted in an Aigis
dome camera. See Figure A on Page 5 for mounting instructions.

INS_CNFE100(X)-A_REV–
06/21/11
PAGE 2
FIGURE 1 – CNFE1002-A
One-Fiber ST Connector
FIGURE 3 – CNFE1004-A
One-Fiber SC Connector
FIGURE 2 – CNFE1003-A
Two-Fiber SC Connector
FIGURE 4 – CNFE1005-A
Two-Fiber ST Connector
INSTALLATION AND OPERATION MANUAL CNFE100(X)-A
TECH SUPPORT: 1.888.678.9427
MULTIMODE
OR SINGLE MODE
OPTICAL FIBER
MULTIMODE
OR SINGLE MODE
OPTICAL FIBER
MULTIMODE
OR SINGLE MODE
OPTICAL FIBER
MULTIMODE
OR SINGLE MODE
OPTICAL FIBER
Power Connector
Power Connector
Power Connector
Power Connector
Ethernet RJ-45
Ethernet RJ-45
Ethernet RJ-45
Ethernet RJ-45

INS_CNFE100(X)-A_REV–
06/21/11
PAGE 3
© 2011 Communications Networks Corporation. All Rights Reserved. “ComNet” and the “ComNet Logo” are registered trademarks of Communication Networks, LLC.
3 CORPORATE DRIVE | DANBURY, CT 06810 | USA
T: 203.796.5300 | F: 203.796.5303 | TECH SUPPORT: 1.888.678.9427 | [e-mail]
8 TURNBERRY PARK ROAD | GILDERSOME | MORLEY | LEEDS, UK LS27 7LE
T: [phone] | F: [phone] | [e-mail]
MECHANICAL INSTALLATION INSTRUCTIONS
INSTALLATION CONSIDERATIONS
This fiber-optic link is supplied as an in-dome mountable module.
Units should be installed in dry locations protected from extremes of
temperature and humidity.
WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated
9-12 VDC @ 1A.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - Consideration should be given to installing
the equipment in an environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment should be such that
the amount of air flow required for safe operation of the equipment is not
compromised.
FIGURE 6 – LED INDICATORS
LINK POWER
GREEN Ethernet link has
been established at
the RJ45 connector.
Unit powered up
OFF Unit Powered Down