Compex wpj558 Installation instructions

hardware guide - wpj558
Compex Systems Pte Ltd | www.compex.com.sg | ([phone] | [email protected] | Last Updated: 02/07/2019 SL
Copyright © Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems Pte Ltd.
While every eort is made to ensure the information is accurate, Compex does not accept liability for any errors or mistakes that may arise.
All specications are subject to change without notice.
1/2
Component Map
Ethernet Port 0
IEEE 802.3af/at or Passive PoE
input minimum 36V
2.4GHz 3x U.FL Connectors
chain0 chain1 chain2
LED Array 2
3.3V Pin Header
GND
+3.3V
USB Header
GND
Data-
Data-
+5V
LED Array 1
Ethernet
Port 1
JTAG Interface
5V Pin HeaderminiPCIe Slot
Serial Port
Buzzer
(Optional)
DC Jack
Power Input:
24 - 56V
Reset Button
(Hardware)
Power Requirements
Power Over Ethernet 1x IEEE 802.3af/at or Passive PoE input minimum 36V
DC Power 1x DC Jack Connector: 12-24V
Power Consumption 8.6 Watts (Max)
Ethernet 0 PINOUT
Pin Signal
1 TX+/POE+
2 TX-/POE+
3 RX+/POE-
4 TX+/POE+
5 TX-/POE+
6 RX-/POE-
7 RX+/POE-
8 RX-/POE-
Serial Port Pin Assignment
Pin Signal
1 VCC – 3.3V
2 UART 0 Transmit Data
3 UART 0 Receive Data
4 GND
JTAG Interface Pin Assignment
Pin Signal Pin Signal
1 TRST_N 2 GND
3 TDI 4 GND
5 TDO 6 GND
7 TMS 8 GND
9 TCK 10 GND
11 RESET 12 NC
13 DINT 14 3V3

hardware guide - wpj558
Compex Systems Pte Ltd | www.compex.com.sg | ([phone] | [email protected] | Last Updated: 02/07/2019 SL
Copyright © Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Systems Pte Ltd.
While every eort is made to ensure the information is accurate, Compex does not accept liability for any errors or mistakes that may arise.
All specications are subject to change without notice.
2/2
LED Array Pin
Array 1 Array 2
Pin Signal Pin Signal
1 RSS4/Diag 1 RSS4/Diag
2 RSS3 2 RSS3
3 RSS2 3 RSS2
4 RSS1 4 RSS1
5 Ethernet 5 Ethernet1
6 Power 6 Ethernet0
7 Power
LED Header
Left pin Right pin Function RSS4/Diag
GND GPIO14 RSS4/Diag RSS4/Diag
GND GPIO15 RSS3 RSS3
GND GPIO22 RSS2 RSS2
GND GPIO23V RSS1 RSS1
GND Ethernet1 LED Ethernet1 Ethernet1
GND Ethernet0 LED Ethernet0 Ethernet0
+3.3V GND Power Power
GPIO Pin Mapping
GPIO Pin Function
GPIO_0 JATG TCK
GPIO_1 JTAG TDI
GPIO_2 JTAG TDO
GPIO_3 JTAG TMS
GPIO_4 BUZZER control
GPIO_5 SPI_CS
GPIO_6 SPI_CLK
GPIO_7 SPI_MI_SI
GPIO_8 SPI_MI_SO
GPIO_9 UART_SIN
GPIO_10 UART_SOUT
GPIO_11 S17_ INTn
GPIO_12 EEPROM DATA
GPIO_13 for usb host mode select.
GPIO_14 RSSI 1
GPIO_15 RSSI 2/ EEPROM CLK
GPIO_16 For OTP disable
GPIO_17 reset
GPIO_18 resever
GPIO_19 resever
GPIO_20 resever
GPIO_21 For PCIE Card on /off
GPIO_22 RSSI3
GPIO_23 RSSI4
miniPCIe Slot Pin Assignment
Top side Bottom side
1 WAKE_L 2 +3.3V
3 NC 4 GND
5 NC 6 NC
7 CLKREQ_L 8 NC
9 GND 10 NC
11 REFCLK- 12 NC
13 REFCLK+ 14 NC
15 GND 16 NC
Mechanical key
17 NC 18 GND
19 NC 20 W_DISABLE_L
21 GND 22 PERST_L
23 PERn0 24 +3.3Vaux
25 PERp0 26 GND
27 GND 28 NC
29 GND 30 SMB_CLK
31 PETn0 32 SMB_DATA
33 PETp0 34 GND
35 GND 36 USB_D-
37 NC 38 USB_D+
39 NC 40 GND
41 NC 42 LED_WWAN_L
43 NC 44 LED_WLAN_L
45 +5V 46 LED_WPAN_L
47 +5V 48 NC
49 +5V 50 GND
51 +5V 52 +3.3V