Compex WPJ558 Installation instructions

hardware guide - wpj558
Compex Systems Pte Ltd | www.compex.com.sg | ([phone] | [email protected] | Last Updated: 01/09/2016 HB
Copyright © Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Inc.
Atheros and other trademarks are properties of their respective owners. While every effort is made to ensure the information is accurate,
Compex does not accept liability for any errors or mistakes that may arise. All specifications are subject to change without notice.
1/2
Component Map
Ethernet Port 0
IEEE 802.3af/at or Passive PoE
input minimum 36V
2.4GHz 3x U.FL Connectors
chain0 chain1 chain2
LED Array 2
3.3V Pin Header
GND
+3.3V
USB Header
GND
Data-
Data-
+5V
LED Array 1
Ethernet
Port 1
JTAG Interface
5V Pin HeaderminiPCIe Slot
Serial Port
Buzzer
(Optional)
DC Jack
Power Input:
24 - 56V
Reset Button
(Hardware)
Power Requirements
Power Over Ethernet 1x IEEE 802.3af/at or Passive PoE input minimum 36V
DC Power 1x DC Jack Connector: 24-56V
Power Consumption 8.6 Watts (Max)
Ethernet 0 PINOUT
Pin Signal
1 TX+/POE+
2 TX-/POE+
3 RX+/POE-
4 TX+/POE+
5 TX-/POE+
6 RX-/POE-
7 RX+/POE-
8 RX-/POE-
Serial Port Pin Assignment
Pin Signal
1 VCC – 3.3V
2 UART 0 Transmit Data
3 UART 0 Receive Data
4 GND
JTAG Interface Pin Assignment
Pin Signal Pin Signal
1 TRST_N 2 GND
3 TDI 4 GND
5 TDO 6 GND
7 TMS 8 GND
9 TCK 10 GND
11 RESET 12 NC
13 DINT 14 3V3

hardware guide - wpj558
Compex Systems Pte Ltd | www.compex.com.sg | ([phone] | [email protected] | Last Updated: 01/09/2016 HB
Copyright © Compex Systems. All rights reserved. COMPEX and the COMPEX logo, are registered trademarks of Compex Inc.
Atheros and other trademarks are properties of their respective owners. While every effort is made to ensure the information is accurate,
Compex does not accept liability for any errors or mistakes that may arise. All specifications are subject to change without notice.
2/2
LED Array Pin
Array 1 Array 2
Pin Signal Pin Signal
1 RSS4/Diag 1 RSS4/Diag
2 RSS3 2 RSS3
3 RSS2 3 RSS2
4 RSS1 4 RSS1
5 Ethernet 5 Ethernet1
6 Power 6 Ethernet0
7 Power
LED Header
Left pin Right pin Function RSS4/Diag
GND GPIO14 RSS4/Diag RSS4/Diag
GND GPIO15 RSS3 RSS3
GND GPIO22 RSS2 RSS2
GND GPIO23V RSS1 RSS1
GND Ethernet1 LED Ethernet1 Ethernet1
GND Ethernet0 LED Ethernet0 Ethernet0
+3.3V GND Power Power
GPIO Pin Mapping
GPIO Pin Function
GPIO_0 JATG TCK
GPIO_1 JTAG TDI
GPIO_2 JTAG TDO
GPIO_3 JTAG TMS
GPIO_4 BUZZER control
GPIO_5 SPI_CS
GPIO_6 SPI_CLK
GPIO_7 SPI_MI_SI
GPIO_8 SPI_MI_SO
GPIO_9 UART_SIN
GPIO_10 UART_SOUT
GPIO_11 S17_ INTn
GPIO_12 EEPROM DATA
GPIO_13 for usb host mode select.
GPIO_14 RSSI 1
GPIO_15 RSSI 2/ EEPROM CLK
GPIO_16 For OTP disable
GPIO_17 reset
GPIO_18 resever
GPIO_19 resever
GPIO_20 resever
GPIO_21 For PCIE Card on /off
GPIO_22 RSSI3
GPIO_23 RSSI4
miniPCIe Slot Pin Assignment
Top side Bottom side
1 WAKE_L 2 +3.3V
3 NC 4 GND
5 NC 6 NC
7 CLKREQ_L 8 NC
9 GND 10 NC
11 REFCLK- 12 NC
13 REFCLK+ 14 NC
15 GND 16 NC
Mechanical key
17 NC 18 GND
19 NC 20 W_DISABLE_L
21 GND 22 PERST_L
23 PERn0 24 +3.3Vaux
25 PERp0 26 GND
27 GND 28 NC
29 GND 30 SMB_CLK
31 PETn0 32 SMB_DATA
33 PETp0 34 GND
35 GND 36 USB_D-
37 NC 38 USB_D+
39 NC 40 GND
41 NC 42 LED_WWAN_L
43 NC 44 LED_WLAN_L
45 +5V 46 LED_WPAN_L
47 +5V 48 NC
49 +5V 50 GND
51 +5V 52 +3.3V