Conlan CM1200 Series User manual

Code & RFID
CM1200/CP1200
CM1200 Mykey - Art. No: 490010 (black), 490011 (white)
CM1200 Classic - Art. No.: 492010 (black), 492011 (white)
CP1200 Mykey - Art. No.: 490015 (black), 490016 (white)
CP1200 Classic - Art. No.: 492015 (black), 492016 (white)
User manual
CM1200-CP1200_usermanual_ENGjul19

2
Introduction
The CM1200 and CP1200 is a combinet keypad and RFID reader for tags and cards
(CM1200 for Mifare and CP1200 for Atmer and Emarine).
The output is a Wiegand format as for other Conlan Wiegande readers. To be used in
connection to other Wiegand controllers or the stand alone Wiegand Controller from
Conlan (Art. No.: 460116).
In standby the yellow LED is lit (● ○ ○)
By correct code or tag/card lights the yellow and green LED (●● ○)
By incorrect code lights the red LED (○ ○ ●)
Installation
Mount the reader on a even surface (use the following drill template for precise t-
ting).
Connect the wires to power supply, Wiegand Controller etc.
Note: Right after applying the voltage all LED’s lights and the buzzer sounds, do not
touch the reader untill the yellow LED is lit and the buzzer is silent.

Conguration
The reader can be set up for dierent Wiegand formats. See the conguration
scheme.
The reader has 3 LED’s and a buzzer to show you what setup you are making.
All programming is by the keypad.
Start up by pressing #2 times within 10 seconds after power on (yellow LED lightens).
The LED’s shows where you are in the schematics.
The naviagtion works by pressing the value of the desired option and it will automati-
cally go down to the next row and so on. When you are done, press #3 times to save
and exit the setup mode.
Example 1: Set up Wiegand key format to Wiegand26 in Singlekey
Within 10 seconds ○ ● ○ ○ ○ ●●● ○ ● ○ ○
To leave the setup mode, press 3 times.
Eample 2: Set up Wiegand RFID format to Wiegand26
Within 10 seconds ○ ● ○ ○ ○ ●●● ○ ● ○ ○
To leave the setup mode, press 3 times.
3
#
Power on 261
#2
#
#
Power on 261
#2
#

Thank you for choosing Conlan’s products.
For further assistance, please contact
Our support service.