Conquer Industry CQL1723-B User manual

CQL1723-B /AR528 Bluetooth Speaker
Instruction Manual (Read before proceeding)
Getting Started
zPlease charge your Bluetooth speaker fully before its first use.
zTo charge the battery:
Using a Micro USB Charging Cable (included), insert the USB power cable into the micro USB port located
on the back of the speaker. Connect the other end of the USB cord into a powered USB source such as a
computer, laptop or USB AC adapter.
zWhen your Bluetooth speaker is charging, the indicator light will turn red.
zOnce your Bluetooth speaker is fully charged, the red light will turn off.
Powering ON/OFF
zSlide the [POWER] switch on the bottom of unit to the ON position to power on. A tone will be heard and the
LED light on and the speaker will enter Bluetooth pairing mode. The speaker will automatically re-pair to
any nearby previously paired devices.
zSlide the [POWER] switch to the OFF position to power off
Playing Music via Bluetooth
zTurn your Bluetooth speaker on by sliding the power switch located on the back of the speaker to ON
position to activate the Bluetooth function.
zA tone will be heard and the speaker will enter Bluetooth pairing mode.
zMake sure the Bluetooth function on your device is turned on.
zSearch the speaker named,” XXX”.
zOnce you have selected the speaker, your device will pair without a password. (If your device prompts for a
password, enter the password”0000”.)
zStart playing music on your device. Make sure that you keep your device within a 33 feet range of your
Bluetooth speaker.
zAdjust the volume of your device to a comfortable level.
zTurn off the unit when not in use.
Using the LED Lights
The LED lights will automatically turn on when the speaker is powered on, and dance to the beat of your music.
For best results, turn the volume up.
Caution:
zThis is not a toy. Please keep away from children.
zPlease keep away from water / heat.
zLow power may cause poor connection even no working of Bluetooth.
zDo not overcharge the battery.
zBattery pack shall not be exposed to excessive heat such as sunshine, fire or the like.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u
sed in portable exposure condition without restriction