Conquer Industry CQL1878-B User manual

CQL1878-B Bluetooth Speaker
Instruction Manual (Read before proceeding)
Power:
zWorks on internal rechargeable Lithium battery. Please charge your speaker fully
before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into the ”Charging” hole on the
back of unit under the silicone cover , then plug the USB connector in to the USB port
on a computer for charging.
zA red light will indicate the charging situation. When battery is full, the red light will
turn off automatically.
Setting Up
zRemove liner from glass, then insert glass tab into speaker base.
Bluetooth Speaker Operation
zTurn on the unit by pushing the switch to “ON” position. The LED light on top will light
on indicate the speaker is in paring mode and searching for your Bluetooth mobile
device.
zOpen the Bluetooth function on your device and search the speaker named “XXX”.
After selecting this speaker, your device will pair without a password. (If required,
enter the password “0000” to finalize the paring).The Blue light will begin to flash
slowly after pair is complete.
zStart playing music on your device. Keep your device within 33feet (10 meters) of
your speaker.
zAdjust the volume of your device to a comfortable level.
zControl play/pause, volume up/next track and volume down/previous track either on
your connected device or by the buttons on the fabric of the speaker.
zTurn off the unit when not in use.
Light Operation
zPush the On Off button to the “On” position to turn on the unit, the light will light up
automatically.
zPlay music on your mobile device, the light will dance to the music.
zTurn off the unit , the light will turn off accordingly.
Caution:
zThis is not a toy. Please keep away from small children.
zPlease keep away from water / heat.
zLow power may cause poor connection even no working of Bluetooth.
zDo not over charge the battery.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u
sed in portable exposure condition without restriction