CONSET SQ147760 User manual

350280.0
Assembly instruction
EN
SQ147760 - SQ147690
This instruction is a supplement to chapter
7 and 8 in the instruction, which is packed
together with the legset

2
7. PARTS
1a 1b 1c
2
4
3
5
6
7
B) x7
C) x10
DO NOT CONNECT TO
POWER BEFORE THE
DESK FRAME HAS BEEN
COMPLETELY ASSEMBLED!
E) x2
D) x1
C) x14
A) x4
B) x4
Not all screws and brackets in the mounting bags are meant
to be used for this desk conguration.

3
8. ASSEMBLY INSTRUCTIONS
1b
2
2
A) x2
1a
B) x2
2.
1. a) connect item 2to item 1b
b) t screws Aand tighten
c) t screws Band tighten
a) connect item 2to item 1a
b) t screws Aand tighten
c) t screws Band tighten
B) x2
A) x2

4
1c
4
3
2
D) x1
5
6
7
4. Mounting the electronic parts and table top
a) see the sketch on page 5 to mount item 56and Din a suitable place
b) with the frame in the upright position t and tighten wood screws Cto secure the table top,
t from underneath, the table top must be tted with the frame fully down, like it comes out the box
c) if the assembled desk has to be moved a few centimeters into it's nal place
you will need minimum 2 people to lift it holding the frame and to place it back down squarely
3. 2 3 4
4
3 1c
Mounting Part 1c : mount third leg center
a) connect item to item and
b) t screws B
c) connect item and to item
d) t screws B
E) x2
C) x15
C) x2
B) x3
B) x4

1a 5
65
5
Wiring
a) connect item to item
b) connect item to item
5
6
5.
1a

6
6.
7.
DO NOT OVER TIGHTEN THE SCREWS
SINCE THIS MAY HARM THE FUNCTION
OF THE CONTROL

7

8