Converters.TV HDMI over CAT5e/6/7 Receiver User manual

HDBaseT Dual HDMI Output over Single
CAT5e/6/7 Receiver - ID 15317
Operation Manual

Introduction
The HDMI over CAT5e/6/7 Receiver is designed to receive an HDBaseT™
signal from a com atible transmitter or matrix unit. It features full 5Play™
convergence allowing the transmission of video, Audio, Control (IR/RS-232),
Power over Ethernet (PoE) and LAN serving over a single CAT5e/6/7 cable
u to 100m.This unit features a simultaneous dual HDMI out ut allowing the
connection of a second dis lay in the same zone. Additionally, it has
bi-directional Power over Ethernet (PoE) functionality that allows for greater
flexibility in installations and LAN serving fuction that allows any connected
device to share network/internet connectivity.
Features
•HDMI (with 3D format and 4K2K resolution su ort), HDCP
and DVI com liant
Dual simultaneous HDMI out uts
Su orts data rates from 250Mb s u to 3Gb s
Su orts a wide range of resolutions - PC from VGA to WUXGA and
HDTV u to 4K2K (3840×2160@30Hz and 4096×2160@24Hz)
Su orts ass-through of high-definition audio formats - LPCM
7.1CH, Dolby TrueHD, Dolby Digital Plus and DTS-HD Master
Audio
Su orts audio sam ling rates from 32kHz to 192kHz
Su orts distances u to 100 meters through CAT5e/6/7 cables
Su orts Ethernet transmission rate u to 100Mb s
Su orts bi-directional IR ass-through
Su orts RS-232 control ass-through
Su orts bi-directional Power over Ethernet (PoE) with com atible
transmitter
Note:
1. This system was tested with CAT6/23AWG cables, results may vary
with cables o a di erent speci ication.
2. The PoE unction is designed or powering compatible Transmitter
units only—non-PoE units will need their own power supply.
Transmitters rom other brands may not be compatible.
3. For playback o 4K × 2K HDMI source signals, a 4K × 2K capable display
and High Speed HDMI cables are required.
Applications
Share a single HDBaseT out ut to 2 HDMI out uts
Household entertainment sharing and control
Showroom dis lay and control
Meeting room resentation and control
Classroom dis lay and control
System Requirements
HDMI source device such as a DVD/Blu-ray layer and an HDMI equi ed
rojector or dis lay (TV or monitor).

Operation Controls
and Functions
Front Panel
1. HDMI OUT 1/2:
Connect each of the HDMI out uts to an HDMI dis lay for simultaneous
HDMI distribution, or cascade the out ut to another transmitter to extend
the o erating distance.
The unit will read the EDID settings of the dis lay device connected to
HDMI OUT 1. If it detects a 4K2K ca able EDID setting it will transmit the
signal in that format to all out uts. If no 4K2K ca able EDID is detected
then the unit will out ut the best resolution that all dis lays can su ort.
Note: The unit will retain and use the EDID settings o the last device
connected to the HDMI OUT 1 output i no device is connected to this
output even a ter switching EDID modes or a power cycle o the
Transmitter unit.
2. LAN:
Connect to an active network for LAN serving.
When the transmitter or any com atible LAN equi ed transmitters are
connected to a network, this allows the network access (including internet
access if available) to be shared between the transmitter and connected
receiver. Connect any Ethernet equi ed device e.g. a Smart TV or games
console to the LAN ort of a receiver for that device to share the
network/internet access.
Warning: DO NOT connect this LAN port to the CAT5e/6/7 port,
doing so may trigger a power shut down and may damage the
device.
3. RS-232 OUT:
Connect to a RS-232 enabled device (with su lied 3.5mm mini-jack to D-
sub 9- in male ada tor) for transmission of RS-232 commands.

Back Panel
1. POWER LED:
This LED will illuminate when the device is connected to a ower su ly.
2. DC 24V:
Connect the 24V DC ower su ly to the receiver and lug the ada tor into
an AC outlet. This unit can also su ly ower to a com atible transmitter
unit
Note: The power supply is not required when using Power over Ethernet
(PoE) rom a compatible transmitter.
The PoE unction is designed or powering compatible Transmitter units
only—non-PoE units will need their own power supply.
Transmitters rom other brands may not be compatible.
3. IR 2 BLASTER:
Connect an IR Blaster cable for IR signal transmission. IR signals received
by an IR extender connected to the transmitter unit will be transmitted by
this blaster. Place the IR Blaster in direct line-of-sight of the equi ment to
be controlled.
4. IR 1 EXTENDER:
Connect an IR Extender cable for IR signal rece tion. Signals received will
be transmitted from any IR blaster connected to the transmitter unit.
Ensure that the remote being used is within the direct line-of-sight of the IR
Extender.
. USB:
This ort is reserved for firmware u date only.
6. LINK LED:
This LED will illuminate when both the source is connected to the
Transmitter and the display is connected to the Receiver.
Note: When the LED blinks regularly it states the Source is NOT
sending signals while the Transmitter and Receiver are linked;
when the LED blinks irregularly it states a link error has occurred;
and when the LED is o there is no link between Transmitter and
Receiver. Please check the connection.
7. CAT e/6/7 IN:
Connect to the transmitter unit with a single CAT5e/6/7 cable (u to
100m/328ft) for transmission of all data signals

IR Pin Assignment
RS-232 Cable
Pin Definitions
PIN DEFINITION
 
 
 
 
 
 
 
 
 

Connection Diagram

Specifications
Video Bandwidth 
Input Ports  !"#$
%&'
("()'*&$+(,-"./0
Output Ports 1'.2!$&)
CAT5e/6/7 Cable Distances %!-3!$
HDMI Cable Distances %!-3!$4)(!-$)(!
HDMI Resolutions %!-55
*4164160
IR Frequency 7816
Power Supply 9*%& %!2"#2$#
 :%,$!(;(#0
ESD Protection 1<32")-#/-#.=
>89*2($)?2#(,@2$?0
>89*,-"!2,!#(,@2$?0
Dimensions 33*A033*033
*10B2,8 ,.<##
33*A033*033
*10B2,8",.<##
Weight ?
Chassis Material !2.
Silkscreen Color '.2,8
Operating Temperature CDEFGHCDEFIJKDELGMCHDEL
Storage Temperature NKCDEFGOCDEFINHDELGMHCDEL
Relative Humidity 7P1*"-"),-"#"("?0
Power Consumption A