Corsair Obsidian 800D Hot Swap Trays User manual

Performance Hardware
User’s Guide
Version 1.0 February, 2010
D r i v e M o u n t i n g i n
8 0 0 D H o t S w a p Tr a y s
Mounting Standard Hard Drives and Solid State Drives into
Corsair Obsidian 800D Hot Swap Trays

Obsidian 800D Hot Swap Trays
1
The Corsair Obsidian 800D case features a 4-drive SATA hot-swap bay. Each
slot has a removable tray which holds 1 drive. These trays can accommodate
either standard 3.5” hard drives (HDs) or 2.5” solid state drives (SSDs).
Mounting is quick and easy for each type of drive.
Hot Swap Tray Overview

Obsidian 800D Hot Swap Trays
2 Mounting an SSD
SSDs require only 2 screws to
mount as seen here circled in red.
Note that the SATA power and data con-
nectors must be mounted away from the
tray handle.

Obsidian 800D Hot Swap Trays
3 SSD Mounted
Note the offset of the SSD. This offset insures proper alignment with the connector
mounted into the hot swap back plane.

Obsidian 800D Hot Swap Trays
4 Mounting a Hard Drive
Hard drives use the holes on each side of the drive. Place screws into each
of the 3 holes on each side of the drive for the most secure mounting. Note
that the SATA power and data connectors are mounted away from the tray
handle

Obsidian 800D Hot Swap Trays
5 The Drives Mounted
The drive trays conform to the SATA standard for physical dimensions.
When properly mounted, the drives are correctly oriented to be inserted into
the hot-swap drive bay. This enables fast and easy drive swapping.

Obsidian 800D Hot Swap Trays
Resources
More information on the Corsair Obsidian 800D case can be found
here: http://www.corsair.com/products/800d/default.aspx
More information on Corsair solid state drives can be found here:
http://www.corsair.com/products/ssd_home.aspx
© February, 2010, Corsair Memory, Incorporated. All rights reserved. All trademarks and registered trade-
marks are the property of their respective owners in the United States and/or other countries.