Courtyard Casual Crestview 5534 Instruction sheet

Page 1 of 5
5534/Crestview 3PC BISTRO SET

1-Person Assembly
1 Minutes Assembly Time
1. Choose an assembly location that is flat and in close
proximity to where product will be used.
2. To prevent scratching of finish, assemble on
clean, soft surface such as carpet or cloth.
3. Remove all packing material, staples, and packing
straps from the carton. Carefully unpack product.
4. Review Part List and Hardware List and ensure all
components are present and in good condition. For
missing or damaged components contact:
[email protected]
1. KEEP ALL HARDWARE OUT OF REACH OF
CHILDREN.
2. TO AVOID ANY RISK OF SUFFOCATION TO
CHILDREN AND ANIMALS, DISPOSE, PLASTIC
PACKING MATERIAL IMMEDIATELY.
1. Prior to each assembly step, identify the required parts .
2. DO NOT sit or stand on partially assembled product.
1. Rated for residential (non-commercial) use only.
2. The chair holds a maximum of 250lbs exceeding
this limit damage on product and may cause injury.
3. Keep fingers away from hinged area of product.
4. The chair is designed for use by one person at
a time.
5. DO NOT use product if any component becomes
damaged. Check all hardware periodically and re-tighten
as necessary.
6. DO NOT stand on the chair and stand or sit on the table.
Use only for intended purpose.
7. DO NOT drag product across floor. Exercise care when
moving product.
8. DO NOT place hot items directly onto product surface.
9. DO NOT use harsh abrasives or commercial cleaners.
Wipe with soft, damp cloth.
10. DO NOT allow liquid of any kind to remain on product.
Absorption may cause surface damage.
ASSEMBLY REQUIREMENT
ASSEMBLY PREPARATION
SAFETY PRECAUTION
ASSEMBLY PRECAUTION
CARE AND USE
MADE IN VIETNAM
5534/Crestview 3PC BISTRO SET
Page 2 of 5

A: Folding table (1)
B: Folding chair (2)
Part List
Page 3 of 5
Before beginning assembly, separate all parts and carefully study the parts diagrams below. Review all
parts and hardware before disposing of any packaging. You may receive extra hardware with your unit.
Contact Kingston Casual Customer Service at for missing hardware. [email protected]
5534/Crestview 3PC BISTRO SET

Move the wooden dowel of the
leg and install it into the hole of
plastic lock following arrows.
Table is ready for use.
Assembly Instructions
STEP 1
Page 4 of 5
5534/Crestview 3PC BISTRO SET

Open the chair following arrow.
Attach the lock under seat part into
the hole in the leg.
The chair is ready for use.
Assembly Instructions
Pull the lock under seat part to
open the chair and pull seat part
following arrow to fold the chair.
STEP 1
STEP 2
Page 5 of 5
5534/Crestview 3PC BISTRO SET