Cozy N Safe EST-586 User manual

ECE R 16 No 44.04
SINAI
Instruction Manual
EST-586
Group 0+/1
Birth to 18kg
(Approximately Birth to 4 years)

2
No child restraint can guarantee absolute protection
from injury in every crash. However to ensure that
your child gets all the protection designed into the
restraint, please read and follow this manual exactly.
GROUP 0+, 1
FITS CHILDREN LESS THAN 18KG

3
EST-586 Car Seat
IMPORTANT TIPS
DO NOT USE THIS CHILD SEAT IN PASSENGER
SEATS EQUIPPED WITH AIRBAGS
1. These fitting instructions should be safely stored in a
place where they can be easily found. Keep it for future
reference.
2. This child seat can be used with the harness for
children less than 18 kg in weight (group 0, 1)
3. This child seat can be installed rearward facing and
forward facing using a three-point lap and diagonal seat
belt.
4. Important-Do not use forward facing before the
child’s weight exceeds 9kg.

4
EST-586 Car Seat
5. Do not use this child seat in the home. It has not been
designed for home use and should only be used in your
car.
6. The safest seating position for this child car seat is on
the rear seat of a vehicle.
7. Never use the child seat without fastening it into the
car.
8. It is dangerous to make any alteration or additions
to the device without the approval of the competent
authority, and a danger of not closely following the
installation instructions provided by the child restraint
manufacturer.
9. Do not leave your child unattended in the seat at any
time.

5
EST-586 Car Seat
10. The seat should be kept away from sunlight if the
seat is not provided with a textile, otherwise it may be
too hot for the child's skin.
11. In the event of an emergency it is important that
the child can be released quickly. This means that the
buckle is not fully tamper proof and so your child must
be taught never to play with the buckle.
12. Any luggage or other objects liable to cause injuries
in the event of a collision should be properly secured.
13. Periodically inspect the harness for wear, paying
particular attention to attachment points. stitching
and adjusting devices.
14. The rigid items and plastic parts of a child restraint
must be so located and installed so that they are not liable

6
EST-586 Car Seat
during everyday use of the vehicle by becoming trapped
by a moveable seat or in a door of the vehicle.
15. Always make sure that any straps holding the seat
restraint to the vehicle are tight, any straps restraining
the child should be adjusted to the childs bodyand check
that the straps are not be twisted.
16. Ensure that any lap straps are worn low down so that
the pelvis is firmly engaged.
17. The seat device should be replaced when it has been
subject to violent stresses in an accident.
18. The instruction manual can be kept on the car seat
restraint during its life period.
19. Do not use any load bearing contact points other
than those described in the instructions and marked in
the child restraint.

7
EST-586 Car Seat
20. Store this child seat in a safe place when it is not
being used. Avoid placing heavy objects on top of it.
Do not allow your child seat to come into contact
with corrosive substances e. g. battary acid.
21. The child restraint must not be used without the
cover. The seat cover should not be replaced with any
other than the one recommended by the manufacturer,
because the cover constitutes an integral part of the
restraint performance.

8
EST-586 Car Seat
Legal requirements
1. This is a “Universal” child restraint, it is approved to
Regulation No 44, 04 series of amendments, for general
use in vehicles and it will fit most, but not all car seats.
2. A correct fit is likely if the vehicle manufacturer has
declared in the vehicle handbook that the vehicle is
capable of accepting a “Universal” child restraint for
this age group.
3. This child restraint has been classified as “Universal”
under more stringent conditions than those which
applied to earlier designs which do not carry this notice

9
EST-586 Car Seat
Legal requirements
4. If in doubt, consult either the child restraint
manufacturer or the retailer.
Only suitable if the vehicle is fitted with 3-point safety
belts, Approved to UN/ECE Regulation No.16 or other
equivalent standards.

10
EST-586 Car Seat
SPECIAL FEATURES

11
EST-586 Car Seat
SPECIAL FEATURES
1. Shoulder straps slots
2. Harnesses cover
3. Safety harness belt
4. Buckle
5. Adjustment plate of seat angle(lever)
6. Adjustment belt
7. Seat fabric belt
8. Metal safety pole ring buckle
9. Metal safety pole
10. Child restraint sitting area
11. Child restraint base
12. Base surpport
13. Blue belt guidance

12
EST-586 Car Seat
INSTALLATION OF THE SEAT IN
THE CAR
Only suitable if the
approved vehicles are
fitted with 3 point
safety-belts, approved
to UN/ECE Regulation
No.16 or other
equivalent standards.

13
EST-586 Car Seat
RECLINE POSITION ADJUSTMENT
To achieve that, use the lever located in fornt of the
child restraint between the sitting part and the base
to adjust thr desire position. Pull up the lever and hold
it, at the same time pull back or forward the sitting
part of the child restraint, then release thr lever while
the sitting part is in the desired position and push it
until you hear a clear audible click sound.

14
EST-586 Car Seat
RECLINE POSITION ADJUSTMENT
The following image shows recline positions
The following picture shows base support recline festure in
rearward facing positions

15
EST-586 Car Seat
INSTALLATION IN THE CAR
Important: Children safety seat must be used on the right
seat of the car.

16
EST-586 Car Seat
ROUTING OF THE SEAT BELT
1. For group 0+ (less than 13kg) use, place the car seat in
rearward facing position on the seat of the car, And make
sure to use red clip.
2. For group 1 (9-18kg) use, place the car seat in forward
facing position on the seat of the car, And make sure to
use red clip.
Warning! : Do not place your child in a sleeping bag,
blanket or other bulky wrapping before putting child in
the restraint. The shoulder straps will no fit securely and
child won’t be safe.
Warning! : To ensure child’s back is evenly supported, do
not put more than one nappy on thr child and make sure
the nappy is not folded at the back.

17
EST-586 Car Seat
INSTALLATION METHODS FOR
CHILD SAFETY SEAT
Group0+ rearward facing

18
EST-586 Car Seat
INSTALLATION METHODS FOR
CHILD SAFETY SEAT
Group0+ rearward facing
Fitting method for rearward facing: Open the base
support and adjust the car seat to the highest angle of
inclination. Place the child seat in rearward facing
position on the seat of the car. Pull the vehicle seat belt
to the front space of child seat between child restraint
sitting part and child restraint base. Make sure that the
lap belt goes through the bule belt guides and feed the
diagonal portion of seatbelt through the metal belt lock
which at the tow sides of the sitting part (see fig I) and
pull the diagonal belt from the backrest of the child seat.

19
EST-586 Car Seat
INSTALLATION METHODS FOR
CHILD SAFETY SEAT
Group0+ rearward facing
Insert the lap and diagonal belt into the car buckle (see
figII) until fasten until you heard “click”. Fasten the seat
belt and pull it tight. Insert the vehicle seatbelt through the
red clip and close it for a secure fit.

20
EST-586 Car Seat
INSTALLATION METHODS FOR
CHILD SAFETY SEAT
Group1 Forward facing