Crestron PYNG-CONNECT-COM Dimensional drawing

DO GUIDE
PYNG-CONNECT-COM
COM Port Expander for PYNG-HUB
Flat Surface Mounting
DO Install PYNG-CONNECT-COM
The Crestron®PYNG-CONNECT-COM can be mounted on a DIN rail, mounted to any at surface, or
placed on a tabletop. If necessary, use screws that are applicable for the mounting scenario.
NOTE: The PYNG-CONNECT-COM can also be rack mounted. For rack mount installation, refer to
the RMK-IFE-1U Installation Guide (Doc. 7615) at www.crestron.com/manuals.
DIN Rail Mounting
NOTE: Do not use the supplied screws to mount the bracket to the bottom of the
PYNG-CONNECT-COM if the device will be DIN rail mounted. Removing the
PYNG-CONNECT-COM from the DIN rail will not be possible.
DO Check the Box
QTY PRODUCT COLOR PART NUM.
1 Bracket, Mounting, Integrated DIN Rail Clip White 4520167
1 Cable, Ethernet, CAT5e, 7' (2.13 m) 2030114
1Connector, 5-Pin 2003577
2 Screw, 6-32 x 3/8", Pan Head, Phillips 2007231

DO GUIDE DOC. 7697D (2041854) 05.17
Specications subject to change without notice.
DO Connect the Device
Connect the PYNG-CONNECT-COM to the network via the included Ethernet cable. The
PYNG-CONNECT-COM is powered via Power over Ethernet (PoE).
PYNG-CONNECT-COM Ports
DO Find Detailed Setup Information
Setup of the PYNG-CONNECT-COM is performed using the Crestron Pyng®app. The Crestron Pyng
app communicates with the PYNG-CONNECT-COM through its connection to the
PYNG-HUB (sold separately). If help is required during setup of the system, refer to the Crestron
Pyng app help screens. For information specic to the current screen, tap in the Crestron Pyng
app to display the available help topics.
NOTE: The hostname is PYNG-C- and the last eight digits of the MAC address. The hostname is
PYNG-C-7F2ED7CB for a PYNG-CONNECT-COM with the MAC address label shown below. The
MAC address label is located on the bottom of the PYNG-CONNECT-COM.
MAC Address Label
DO Learn More
Visit the website for additional information and the latest rmware updates. To learn
more about this product, use a QR reader application on your mobile device to scan
the QR image.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specications for CE marking.
This product is Listed to applicable UL®Standards and requirements tested by Underwriters Laboratories Inc.
Ce produit est homologué selon les normes et les exigences UL applicables par Underwriters Laboratories Inc
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modications not expressly approved by the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
The Crestron Pyng application and its use by end-users are governed by both the Terms of Use for Crestron Mobile Cloud Computing Applications as well as the Privacy Statement for Crestron
Mobile Cloud Computing Applications which can be found on the Crestron website at www.crestron.com/legal/mobile_cloud_apps_tos_privacy. Crestron product operating system software,
including Crestron Pyng, is licensed to Crestron dealers, CSPs, and end-users under an End-User License Agreement which can be found on the Crestron website at www.crestron.com/legal/
software_license_agreement.
The specic patents that cover Crestron products are listed at patents.crestron.com. Product warranty can be found at www.crestron.com/warranty.
Crestron, the Crestron logo, and Crestron Pyng are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. UL and the UL logo are
either trademarks or registered trademarks of Underwriters Laboratories, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be
used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is
not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2017 Crestron Electronics, Inc.
LAN PoE:
Power and 10BASE-T /
100BASE-TX Ethernet
from a PoE injector or
switch
COM:
To security system