Crestron TPMC-CH-IMW User manual

Crestron TPMC-CH-IMW
CAT5 Balanced AV Interface Wall Plate
Operations Guide

This document was prepared and written by the Technical Documentation department at:
Crestron Electronics, Inc.
15 Volvo Drive
Rockleigh, NJ 07647
1-888-CRESTRON
All brand names, product names and trademarks are the property of their respective owners.
©2006 Crestron Electronics, Inc.

Crestron TPMC-CH-IMW CAT5 Balanced AV Interface Wall Plate
Contents
CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW 1
Introduction......................................................................................1
Features & Functions.............................................................1
Specifications.........................................................................2
Physical Description ..............................................................4
Industry Compliance............................................................10
Setup...............................................................................................11
Network Wiring...................................................................11
CAT5 Wiring .......................................................................11
Hardware Hookup................................................................11
Problem Solving.............................................................................15
Troubleshooting...................................................................15
Check Network Wiring........................................................15
Reference Documents..........................................................17
Further Inquiries ..................................................................17
Future Updates.....................................................................17
Return and Warranty Policies ........................................................18
Merchandise Returns / Repair Service ................................18
CRESTRON Limited Warranty ..........................................18
Operations Guide - DOC. 6448 Contents •i

Crestron TPMC-CH-IMW CAT5 Balanced AV Interface Wall Plate
CAT5 Balanced AV Interface Wall
Plate: TPMC-CH-IMW
Introduction
Features & Functions
• CAT5 Balanced AV Interface Wall Plate for Isys®TPS and
TPMC-CH touchpanels*
• Mounts in a 2-gang electrical box
• Uses CresCAT™-D cable to carry Cresnet®, bidirectional
audio, and video signals up to 500 feet
• Carries 24 Volts DC power to touchpanels that require power
from the NET connector
• Supports composite, S-video, and component video
• Connects to conventional audio and coaxial video sources
*The TPMC-CH-IMW is not compatible with QuickMedia™ touchpanels or
touchpanels with a 10-pin RJ-45 NET/VIDEO connector.
Operations Guide – DOC. 6448 CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW •1

CAT5 Balanced AV Interface Wall Plate Crestron TPMC-CH-IMW
Specifications
Specifications for the TPMC-CH-IMW are listed in the following table.
TPMC-CH-IMW Specifications
SPECIFICATION DETAILS
Front Panel
AUDIO
Output Impedance
Maximum Output Level
Input Impedance
VIDEO
Output Impedance
RJ-45 female, CAT5 balanced audio
input/output port
100 ohms balanced
2 VRMS
Infinite (unbuffered pass-thru to rear
AUDIO OUT port)
RJ-45 female, CAT5 balanced video
output port carries composite, S-video,
and component signals to touchpanel
100 ohms balanced
Rear Panel
VIDEO
Input Impedance
Input Level
Maximum DC Offset
AUDIO IN
Input Impedance
Maximum Input Level
AUDIO OUT
9-pin terminal block connector for
video input to touchpanel.
100 ohms balanced
(also accepts 75 ohm unbalanced)
1 Vp-p nominal, 1.5 Vp-p maximum
1.5 Volts
5-pin terminal block connector.
Balanced/unbalanced stereo line-level
input to touchpanel.
20k ohm balanced,
10k ohm unbalanced
4 VRMS balanced,
2 VRMS unbalanced
5-pin terminal block connector.
Balanced stereo line-level output from
touchpanel (unbuffered pass-thru from
front AUDIO port).
(continued on following page)
2 •CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW Operations Guide – DOC. 6448

Crestron TPMC-CH-IMW CAT5 Balanced AV Interface Wall Plate
TPMC-CH-IMW Specifications (continued)
SPECIFICATION DETAILS
Power Requirements
Cresnet Power Usage 2 Watts (0.08 Amps @ 24 Volts DC)
Environmental
Temperature
Humidity
41° to 122°F (5° to 50°C)
10% to 90% RH (non-condensing)
Enclosure 2-gang mountable in a standard
electrical box (2.5 inch deep
minimum). Includes black metal front
panel Decora®inserts; requires
Decora faceplate (provided by others).
Dimensions
Height
Width
Depth
4.11 in (10.44 cm)
3.50 in (8.89 cm)
1.66 in (4.22 cm)
Weight 7.5 oz (0.21 kg)
Operations Guide – DOC. 6448 CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW •3

CAT5 Balanced AV Interface Wall Plate Crestron TPMC-CH-IMW
Physical Description
This section provides information on the connections and indicators
available on your TPMC-CH-IMW.
Physical View of the TPMC-CH-IMW, Front
4 •CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW Operations Guide – DOC. 6448

Crestron TPMC-CH-IMW CAT5 Balanced AV Interface Wall Plate
Physical View of the TPMC-CH-IMW, Rear
Operations Guide – DOC. 6448 CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW •5

CAT5 Balanced AV Interface Wall Plate Crestron TPMC-CH-IMW
TPMC-CH-IMW Overall Dimensions
(Clockwise from top – Front, Side, Rear)
3.50 in
(8.89 cm)
1.49 in
(3.78 cm)
4.11 in
(10.44 cm)
1.66 in
(4.22 cm)
1 2 3 4
5 6 7 8
6 •CAT5 Balanced AV Interface Wall Plate: TPMC-CH-IMW Operations Guide – DOC. 6448