Crestron CHV-TSTAT-FCU-HOTEL User manual

CHV-TSTAT-FCU-HOTEL
Heating and Cooling Thermostat (Fan Coil Unit)
quickstart guide
For details, refer to the CHV-TSTAT-FCU-HOTEL Operations & Installation
Guide, Doc. 7543.
QUICKSTART DOC. 7544A (2037050) 04.14
1
CHV-TSTAT-FCU-HOTEL
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
Mount the Crestron
®
thermostat
directly to drywall or to a single-gang
box in accordance with accepted
building codes and practices. If
using the single-gang box, be sure
to fill it with thermal insulation
material.
For additional details and installation
options, refer to the
CHV-TSTAT-FCU-HOTEL
Operations & Installation Guide
(Doc. 7543) at
www.crestron.com/manuals.
Mounting
1
2
Wiring
Connect the thermostat using the wiring configurations shown below as a guide. Place the jumper on the lower two
pins. For more information, refer to the CHV-TSTAT-FCU-HOTEL Operations & Installation Guide (Doc. 7543).
CHV-RTS
TOP
24V
Y
Z
G
NETWORK
TOP
24V
Y
Z
G
NETWORK
Reference
Power
Cool Valve
Heat Valve
Fan High
Fan Medium
Fan Low
To Cresnet®

Heating and Cooling Thermostat (Fan Coil Unit)
quickstart guide
For details, refer to the CHV-TSTAT-FCU-HOTEL Operations & Installation
Guide, Doc. 7543.
QUICKSTART DOC. 7544A (2037050) 04.14
CHV-TSTAT-FCU-HOTEL
www.crestron.com
888.273.7876 201.767.3400
Specifications subject to
change without notice.
2
3
To enter Setup mode, press and hold °F / °C and FAN for about 5 seconds.
The display shows the setup screens. Refer to the CHV-TSTAT-FCU-HOTEL
Operations & Installation Guide (Doc. 7543) for detailed information on setup
and operating modes.
Basic Thermostat Setup 4System Modes and Fan Operation
Press the FAN button to cycle the unit
through available speeds: FAN AUTO,
FAN HIGH, FAN MEDIUM, FAN LOW, and
OFF.
•Fan speed changes take place upon
release of the FAN button.
•The selected fan speed becomes
operational 3 seconds after the mode has
been entered.
•The fan operates only when there is a
cool or heat call.
Press the °F/°C button to toggle the display
between Fahrenheit and Celsius.
Use the kand jbuttons to choose the
desired temperature set point.
Thermostat Display Key
Typical Heat
Mode Display
Typical Cool
Mode Display
CHV-TSTAT-FCU-HOTEL
The specific patents that cover Crestron products are listed at patents.crestron.com.
Crestron, the the Crestron logo, and Cresnet are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries.
Other trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products.
Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2014 Crestron Electronics, Inc.
F
HEATING
AUTO TEMP
HOLD
H FM
F
COOLING
AUTO TEMP
HOLD
C FH
F
HEATING
AUTO TEMP
HOLD
H FM
Heat (H) or Cool (C) Call
Heat (H) or Cool (C)
Call and Fan Speed
Indicator
Fan Speed
Ambient
Temperature Setpoint Temperature Unit