Curtis TC Series Datasheet

Service & Sales
1-800-421-6150 www.wilburcurtis.com
ITEM
#
PART # DESCRIPTION
1 WC-3202
1
KNOB, LID (USE ON OLDER UNITS)
2A WC-56023 LID, STACKABLE TC-2H/3H/5H
2B WC-56042
2
LID, STACKABLE TCS5
2C WC-5635
3
LID, TC-3.5 BREW THROUGH
2D WC-5602
4
LID W/KNOB TC-10
2E WC-5612
5
LID 10-5/8 W/KNOB TC-5HS (OLDER UNITS)
3 WC-3800
LABEL, ICED TEA CURTIS
4 WC-3006
6ADAPTER, TC PLUG SST.
5 WC-4306-102
6WASHER, .875” O.D X.625IDX.093 THK TEFLON
6 WC-4304
6O-RING, .468 ID x .624OD X .07 8CS RED SIL. 70
SHORE
7 WC-3005
6ADAPTER, TC UNION SS
8 WC-1905
NUT, WING PLASTIC 1-1/32-14UNF (TC-2,3,5,10)
9 WC-1906
“C” RING .917 X .760 X .090 TT-3 TC’S
10 WC-1805
SEAT CUP, “S” FAU. USE ON
WC-1800/B/LB/D/DL/L/WC-1803
11 WC-1803
FAUCET, “SPB” SERIES BLACK PLATIC 1-1/32-14
UNS
12 WC-3707
KIT, FAUCET SPB SERIES USE ON WC-1803
INSTRUCTIONS AND PARTS LIST
TC SERIES ICED TEA DISPENSERS
WARNING:
• Clean the container completely before using it for the first time according to the DAILY CLEANING
INSTRUCTIONS (back). Clean it regularly as instructed in the DAILY CLEANING INSTRUCTIONS.
• This product can expose you to chemicals including Acrylamide and Bisphenol A (BPA), which are
known to the State of California to cause cancer and birth defects or other reproductive harm. For
more information visit www.P65Warnings.ca.gov.
PARTS LIST
2A
2B
2C
2D
2E
3
1
4
5
6
7
8
9
12
11
10
1 Replacement knob for older units
2 Used on TC-6H and TC-7H
3 Used on TC-5HV (for spare parts only)
4 Used on TC-10H and older TC-6H and TC-7H units
5 Used on TC-5HS and other older units (for spare parts only)
6 On some newer units, the adapter (item 7) is welded directly
to the container and is not replaceable. Items 4, 5, 6 are
omitted on these units.
NOTES:

Wilbur Curtis Co., Inc.
Mail: 6913 Acco Street, Montebello, CA 90640-5403 U.S.A.
Phone: [phone] │ Fax: [phone] │ Technical Support Phone: [phone] (M-F 5:30 a.m.- 4:00 p.m. PST) │ Email: [email protected] │ www.wilburcurtis.com
05/2020 F-1868 revK
NOTICE - Do not use cleaning liquids, compounds or powders containing chlorine (bleach) or corrosives.
These products promote corrosion and will damage the nishes. USE OF THESE PRODUCTS WILL VOID THE
WARRANTY.
DAILY CLEANING INSTRUCTIONS
The following cleaning process requires a mild solution
of dish-washing detergent and warm water, and One-Pro
Beverage Equipment Cleaner (Curtis PN WC-79001).
Mix the One-Pro cleaner at a ratio of 1 oz. (28 g.) per
5 gal. (19 L) of hot water (122°F/50°C min.).
Container
1 Prepare a mild solution of detergent and warm water.
Remove the container from the brewer and remove the
lid. Rinse.
2 Wash - Wipe the exterior surfaces with a sponge and
the detergent solution to remove spills and debris. Use
the detergent solution and a soft bristled brush to wash
the inside of the container.
3 Rinse - Rinse with clean, warm water.
4 Sanitize - Fill the container to the top with One-Pro
cleaning solution, mixed as specied above. Allow
the mixture to soak for 15 minutes, then drain. Fill the
container to the top with warm clean water, then drain.
Fill with water and drain a second time.
5 Disassemble the faucet - Unscrew the faucet assembly
from the container. Then, unscrew the handle/bonnet
assembly from the top of the faucet and remove.
Inspect the seat cup for wear. Replace the seat cup if it
is damaged.
6 Air Dry - Turn the container upside down and allow to
air dry.
Faucet Parts and Lid
7 Wash - Wash the lid and faucet parts with the
detergent solution.
8 Rinse - Thoroughly rinse all parts with clean, warm
water.
9 Sanitize - After rinsing, place the faucet parts in One-
Pro solution, mixed as specied above, and allow them
to soak for 15 minutes.
10 Air Dry - Remove the parts from the sanitizer, rinse
them off thoroughly, and allow them to air dry.
11 Reassemble - When dry, reassemble the handle/
bonnet. Hand tighten the handle/bonnet onto the top of
the faucet assembly. Hand-tighten the faucet assembly
onto the container outlet.
WASH
RINSE
SANITIZE
Seat cup
Faucet
Handle
Bonnet
To dis-assemble the top of
the faucet, grasp the bonnet
and push up on the seat cup,
while unhooking the handle.