custom alarm Vista User manual

Disarm
Enter 4 digit code + 1 (Disarm)
Arm Stay (No Motion Sensors)
Enter 4 digit code + 3 (Stay)
(if ‘Quick Arm’ is enabled, press # + 3)
Arm Night (No Motion, No Door Delay)
Enter 4 digit code +7 (Instant)
(if ‘Quick Arm’ is enabled, press # + 7)
Arm Away (Motion Sensors On)
Enter 4 digit code +2 (Away)
(if ‘Quick Arm’ is enabled, press # + 2)
Check System Status
Press *to show if any sensors are currently open or in trouble.
Clearing an Alarm
Enter 4 digit code + 1 (Disarm) once to silence, then repeat 4 digit code + 1
(Disarm) to clear alarm and disarm fully.
Bypass a Problem Zone
•Know which Sensor (zone) is having the issue. Press *and the display will
scroll any troubled/opened zone names, along with a 2 digit number for it.
•You will need to do this command sequence once per zone number if
there are multiple sensors being bypassed.
•Once you have found your problem zone number(s), type your 4 digit code
+ 6 (BYPASS) + Zone number (03, 09, 15, 22, etc.)
•Once all open/troubled zones are bypassed, the system can be armed as
normal. The bypasses will clear upon the next disarm, and will need to be
re-bypassed when attempting to arm again.
Enable Door Chime (Keypad beeps when door opens)
Enter 4 digit code + 9 (Chime) - The display will indicate whether the
chimeisonoro.RepeatthecommandtoswitchbetweenOn/O.
Vista
Quick Reference Guide

User Codes
Before continuing, if you have the ability to Arm/Disarm your system
remotely using either the Alarm.com or TotalConnect 2.0 App/Website, it
is strongly recommended you only make changes to user codes through
the App/Website. Doing so manually using the following steps can cause
issues with the App/Website connection with your system.
Codes are edited by using a command sequence. The rst part is the
Master Code, the next is the Code (8) function/menu, and the next is the
User Number (03, 10,16, etc.), and nally the new code.
Add new code/user for slot 03
Example: Master Code (1234) + 8 (Code Function) + 03 (User Number) +
2580 (New Code for user 03)
Change code for existing user 03
Example: Master Code (1234) + 8 (Code Function) + 03 (User Number) +
9855 (New Code for User 03)
Delete code for user 03
Example: Master Code (1234) + 8 (Code Function) + 03 (User Number +
# + 0
Changing the Master Code (Master is always User 02)
Example: Master Code (1234) + 8 (Code Function) + 02 (User Number) +
5258 + 5258 (New Master Code twice)
Uponcompletinganyoftheabovesteps,youshouldgetaconrmation
chime sound from the keypad. It is recommended that you test whether
your new code has been added/removed by trying to Arm/Disarm with it.
Add/Change/Delete Codes
507.288.5522 | custom-alarm.com
Click to watch Vista Video Tutorials