Cygolite Metro 420 User manual

• Ultra bright 420 & 300 lumen outputs
• Precision optics
• 5 Lighting modes
(Med > Hi > Low > 2-in-1 SteadypulseTM > Day Flash)
• Internal USB rechargeable Li-Ion battery
• Side illumination ports for added visibility
• Water resistant design
• Feather-light 110 grams
• LocktiteTM tool-free handlebar mount
OPERATION MANUALOPERATION MANUAL
OPERATION MANUALOPERATION MANUAL
OPERATION MANUAL
CONTENTS
•SuperbrightLEDHeadlight
• USB cable
•Handlebarbracket
Congratulations on your purchase of the Metro high-brightness LED
headlight system. Please refer to this guide to operate your Metro
safely and properly.
Super Bright LED Bicycle Lighting System
with USB rechargeable Li-Ion battery
CAUTION:
· Headlight may get hot during use. Use caution when handling.
· Unplug the headlight from charger when not in use.
· Unplug connectors by the plug, never by the cable.
· Do not modify or substitute any parts with non-Cygolite parts.
· Do not open headlight case.
· Provide adequate airflow to the headlight to cool during use.
· If the light is on & stationary longer than 10 minutes, turn it off.
· Do not look directly at light.
· Do not operate or submerge under water.
· Do not operate the light unattended.
· Keep headlight away from combustible materials.
· Do not package headunit when hot or immediately after use.
· Carrying a flash light is recommended.
· This light is for bicycle use only.
· State laws regarding flashing bicycle lights may vary among states. Use the flashing
modes in accordance to your local state laws as well as federal law.
Metro 420 / 300
TM
FEATURESFEATURES
FEATURESFEATURES
FEATURES
CONTENTSCONTENTS
CONTENTSCONTENTS
CONTENTS
The Metro features 5 light settings controlled by the power button. During
use, the power button will illuminate to show the power is on. The diagram
and instructions below indicate where the light features are located on the
headlight.
CAUTION: The light may get hot during use. Handle with care and turn
light off if stationary for more than 10 minutes.
OPERATION
1. Press power button to operate the light. The light will turn on and the
power button will illuminate.
2. Press power button to scroll through the different settings.
3. Hold the power button for 2 second to turn the light off.
LIGHT MODE MEMORY
For convenience, the Metro memorizes the last mode used before it is
turned off. When it is turned back on, it will turn on in that mode.
LIGHT SETTINGS
Med > High > Low > 2-in-1 Steadypulse > Day Flash
2-in-1 Steadypulse setting combines steady brightness to see and
alerting flash to be seen into one setting. It is made especially for riding
at night in high traffic areas.
SIDE ILLUMINATION PORTS
During use, the side ports will illuminate to provide added side visibility to
adjacent motorists and traffic.
LOW BATTERY
If the light dims dramatically during use, the battery is near empty. At this time
we recommend stop using the light and recharge it immediately.
HEADLIGHT OPERATIONHEADLIGHT OPERATION
HEADLIGHT OPERATIONHEADLIGHT OPERATION
HEADLIGHT OPERATION
Power Button
(During use)
Solid = Light On
USB port
Side Illumination ports
3. Wrap bracket around handlebar, return thumbnut in slotted space, twist
thumbnut clockwise to tighten.
4. Slide headlight back into the bracket until headlight clicks into place.
5. To remove headlight, press the release tab on the bracket and slide the
headunit forward.
34
Thumbnut
Release Tab
The LocktiteTM handlebar bracket has a tool-free design to let you mount
the bracket on the handlebar with ease while firmly staying in place
through all riding conditions.
1. Attach handlebar spacers to inside of handlebar bracket for standard
sized handlebars. Remove spacers for oversized handlebars.
2. Attach rubber pad to handlebar spacer (or handlebar bracket) for grip.
MOUNTING ON HANDLEBARSMOUNTING ON HANDLEBARS
MOUNTING ON HANDLEBARSMOUNTING ON HANDLEBARS
MOUNTING ON HANDLEBARS
Rubber pad
Attach Handlebar spacers
(for standard sized bars)
ADJUST THE SIDE-TO-SIDE BEAM DIRECTION
Swivel the headlight left to right to adjust the side-
to-side direction. If side swivel becomes loose,
tighten the swivel screw on the top of the bracket
with a philips screwdriver.
ADJUSTING THE VERTICAL BEAM DIRECTION
Twist bracket thumbnut counterclockwise to loosen
bracket. Rotate bracket around handlbar for
preferred vertical beam angle then tighten
thumbnut.
1
2
OPTIONAL MOUNTING
An optional helmet mount kit (Part No. HLMT-DCV6) is available for this
light. To order, call Cygolite customer service or order online at:
shop.cygolite.com
Thumbnut

Charging Port
Rubber Cover
WARNING: Fully charge the battery before first time use. We
recommend to charge the battery with the supplied USB cable. If using
another USB cable or charger, check the power button to verify the light
is taking a proper charge. The button will iluminate to show its charging
status. The charger is for indoor use only.
3
1. Pull the top of the rubber cover to reveal the charging port.
(Do not remove rubber cover from light)
2. Connect the USB charging cable to your computer’s USB port.
3. Insert charging cable into the USB charging port on back of light.
4. The power button on top of the light will flash green when charging
then have a steady green when fully charged.
5. Allow approximately 5 continuous hours to fully charge.
6. Disconnect the cables when charging is complete and cover charging
port with rubber cover.
BATTERY CHARGINGBATTERY CHARGING
BATTERY CHARGINGBATTERY CHARGING
BATTERY CHARGING
1
RUN TIMESRUN TIMES
RUN TIMESRUN TIMES
RUN TIMES
Power Button
(During charging)
Flash
Solid
= Charging
= Full
2
4
OPTIONAL WALL CHARGING
If you prefer to charge directly through a wall outlet, an optional wall
charger (Part No. ND-0501000U) is available. To order, call Cygolite
customer service or order online at: shop.cygolite.com
High
1:40
2
Med
2:30
3
Low
10
13
Day Flash
25
25
Light Modes (hr:min)
Model
METRO 420
METRO 300
S-Pulse
3
3:30
CYGOLITE
1307-A EAST SAINT GERTRUDE PL., SANTA ANA, CA 92705 USA
PHONE: [phone] FAX: [phone]
www.cygolite.com
In the USA, the Metro comes with a lifetime limited warranty on the light
housing and one year warranty on electrical parts, against any defective
part or craftsmanship. The battery is warranted up to 6 months after the
original date of purchase. If the unit is under warranty, Cygolite will repair
or replace defective components at no charge provided the product has not
been subject to misuse, abuse, or non-Cygolite authorized alteration,
modification or repair. Warranted products requiring service must receive a
Return Merchandise Authorization number (RMA#) from customer service.
The original receipt (INCLUDING DATE) is required on all warranty repairs.
Shipping costs inccurred from shipping warranty or repair items from the
customer to Cygolite are covered by the customer. For warranty issues
outside the USA, contact the retailer where the purchase was made.
The headlight will not turn on.
· Make sure the power button was firmly pressed.
· Make sure the battery is fully charged.
All Cygolite products are backed by Cygolite’s warranty, providing
quality, craftsmanship, and the assistance of our knowledgeable staff.
If any support is needed, we will assist with 48 hour turnarounds on parts
and service. For questions, problems, and/or authorized Cygolite parts
contact us.
The Metro series is designed to be used on bikes in some of the most
extreme outdoor conditions. Over time, dust and dirt may hinder the
connections on your headlight. To prevent this from happening, ensure that
the headlight is clean after every ride.
Wipe the headlight with a damp cloth. Do not submerge the battery or
headlight in water. Remove all dirt around or on the plugs or jacks on the
headlight.
The High-Brightness LED has extensive life so bulb replacement is not
required.
WARRANTYWARRANTY
WARRANTYWARRANTY
WARRANTY
COMMITMENTCOMMITMENT
COMMITMENTCOMMITMENT
COMMITMENT
CARECARE
CARECARE
CARE
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTINGTROUBLESHOOTING
TROUBLESHOOTING
Q: When should I replace the bulb?
· The LED bulb has extensive life so bulb replacement is not neeeded.
Q: When should I charge my battery?
·
If the light dims dramatically during use, the battery is low. At this
time we recommend to turn the light off and charge immediately.
Cygolite recommends to monitor your run times and charge your
light according to its use. The battery can be charged any time, but
we recommend fully charging the battery every time you charge it.
Q: Can I use non-Cygolite parts for this unit?
· No, Cygolite parts are manufactured to specific quality
specifications. To ensure the quality of your lighting system,
only use Cygolite parts. Use of non-Cygolite parts will void the
warranty and may cause damage to the light.
Q: Can I leave my light charging for extended periods of time?
· Yes, the light is smart charging & will prevent from overcharging but
like all electrical appliances we recommend disconnecting the
headlight and charger when the light is fully charged.
Q: Will my Non-Cygolite USB charger recharge the Metro?
· Cygolite recommends to use the provided Cygolite USB cable
(or optional wall charger) to properly charge the Metro. Non-
Cygolite USB chargers can charge the Metro but make sure the
charger plug matches the USB port of the light and the power
button indicates the light is taking a charge. If the power button
does not illuminate when charging, charge the light with the
supplied USB cable.
Q: Can I use this light for activities other than cycling?
· No, this light is specifically intended for bicycle use only.
Q: What if water gets into the side illumination ports?
· The side illumination ports are sealed to prevent water from
damaging the internal electronics. If water is inside the ports put the
light in a dry place and allow the water to dry.
Q: What if the battery needs replacement?
· If the battery ever needs replacement, contact Cygolite customer
service to arrange the battery relacement.
If you have more questions that are not listed here,
visit the support page at: www.cygolite.com
F.A.Q.sF.A.Q.s
F.A.Q.sF.A.Q.s
F.A.Q.s