Cypress enCoRe III CY3664-EXT Instruction manual

CY3664-EXT enCoRe™ III DEVELOPMENT KIT
QUICK START GUIDE
1. Unpack the CY3664-EXT enCoRe III kit
contents including application board,
MiniProg1, USB A to mini-B cable,
resistor/wire pack, and power supply
adaptor.
1. Insert the kit CD/DVD into the CD/DVD
drive of your PC.
2. Install the kit contents.
1. Attach a wire from P00 on J5 to S1 on
J2, to activate button S1.
2. Connect the mini-B side of the USB A to
mini-B cable to the application board.
Connect the A side of the cable to the
PC.
3. The board enumerates as a USB mouse
HID device.
1. On the PC, go to Control Panel >
Mouse > Pointer Options; clear the
'Enhance pointer precision' option.
2. Open a simple drawing application,
such as Paint.
3. The mouse cursor moves in the shape of
the letters U, S, and B. Press the S1
button on the DVK to stop drawing.
4. Press the S1 button on the DVK board to
toggle the start and stop of drawing in
the drawing application.
1 2
3 4
All manuals and user guides at all-guides.com

© 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners. Doc#: 001-71696 Rev. *A
http://www.cypress.com/go/CY3664-EXT
For the latest information about this kit, visit
CY3664-EXT enCoRe™ III DEVELOPMENT KIT
QUICK START GUIDE
CY3664-EXT Application Board Details
Solderless Breadboard enCoRe III chip No. CY7C64215
All manuals and user guides at all-guides.com