Cypress CY15FRAMKIT-002 User manual

CY15FRAMKIT-002 Features:
•Excelon 108MHz QSPI F-RAM
•ST NUCLEO-433LC-P compatible Morpho headers (J9, J10)
•Arduino UNO R3 compatible I/O Header (J1 - J4)
•Headers J8 (1A-8A), J8 (1B-8B), J8 (1C-8C) to select Arduino or
Morpho connector signal connectivity to F-RAM device
•J5 header for 1.8-V/3.3-V F-RAM device VDD power supply selection
•J6 header for 1.8-V/3.3-V selection for level shifters. Set this to
the base board's power supply value
CY15FRAMKIT-002 SERIAL F-RAM DEVELOPMENT KIT
QUICK START GUIDE
Morpho Headers (J9, J10)
Headers (J8)
Excelon 4-Mbit F-RAM
Arduino Headers (J1-J4)

• This kit is designed to work with the ST NUCLEO-433LC-P board or an Arduino
UNO R3 compatible board
•Download the kit rmware from: www.cypress.com/CY15FRAMKIT-002
• Follow the Kit Operation Chapter 3 in CY15FRAMKIT-002 User guide for MCU
conguration and programming
• Ensure that Jumpers J5 and J6 on Kit are set for 3.3V operation
• Ensure that Jumpers J8 (1B-8B) and J8 (1C -8C) are all shorted
• Connect the MCU and F-RAM Kit as shown below to USB port
• Open a UART terminal, select the Nucleo board and press B2 (Reset button)
on the Nucleo board
• On Successful programing, a GUI menu will be displayed on the terminal as
shown in Appendix B of User Guide
CY15FRAMKIT-002 SERIAL F-RAM DEVELOPMENT KIT
QUICK START GUIDE
© 2019 Cypress Semiconductor Corporation. All rights reserved.
All trademarks or registered trademarks referenced herein are the
properties of their respective owners. Doc.# 002-27301 Rev.*A
Download the kit User Guide, driver, and hardware les from:
www.cypress.com/CY15FRAMKIT-002
For technical support, visit www.cypress.com/support
CY15FRAMKIT-002 Kit with ST NUCLEO-433LC-P Board