D-Box HaptiSync Hub User manual

Vertical
Horizontal
Package Contents
• 1x HaptiSync Hub
• 1x Power Cord
You also need:
(included in seat package)
• 1x D-BOX Haptic Seat
(at least)
• 1x Power Cord
• 1x IEC Plug-Lock Insert
• 3 or 4x Stabilization Cups
(varies per model)
• 1x CAT.5E Shielded Cable
Complete User Manual is accessible at:
https://www.d-box.com/en/downloads/
• Connect the HaptiSync Hub to the Haptic Seat
using the CAT.5E shielded cable provided with
the system. See other side of this page or the
user manual for a specic wiring diagrams.
• Plug your HaptiSync Hub and your Haptic Seat
into an electrical outlet.
• Press the power button on your HaptiSync Hub
to turn it on.
3 Create your D-BOX Connect Account
• Go to the D-BOX Connect website:
https://connect.d-box.com
• Create an account using a valid email address;
• Edit your payment information. (Please note
that a valid credit card is required to complete
your registration).
• Purchase your D-BOX connect subscription.
Complete HaptiSync conguration
from the D-BOX Connect website
• Install the D-BOX HaptiSync App
• Connect your HaptiSync Hub to your network
• Activate your HaptiSync Hub
• Test your HaptiSync System
• Enjoy your favorite immersive content!
1 Position your HaptiSync Hub
• Install your HaptiSync Hub on a at surface
• Center your HaptiSync Hub in the audio envi-
ronment and aim the integrated audio sensor
(front side) towards your front speakers.:
2 Prepare your Haptic Seat
• Install the stabilization cups under your
Haptic Seat:
• Make sure nothing will be pinched or
damaged while the Haptic Seat is moving.
4
242-914-0028-EN1 | November 2020
Quick Start Guide

HAPTISYNC SYSTEM
Wiring diagrams
HAPTISYNC HUB
Internet WiFi
Rear view 100-240VAC, 50/60Hz, 2A 120VAC, 50/60Hz, 5A
HAPTISYNC SYSTEM(S)
Use CAT.5E/6
(Shielded Cable only)
LAN (Optional)
Audio IN
(Optional – See section 4)
Internet
Rear viewFront view
Terminaison cable must be connected
into the OUT port
Rear panel
HAPTISYNC HUB
Internet WiFi
Rear view 100-240VAC, 50/60Hz, 2A
GEN-1 HAPTIC SYSTEM
Use CAT.5E/6 (Shielded Cable only)
LAN (Optional)
Audio IN (Optional – See section 4)
Internet
Terminaison cable must be connected
into the OUT port
KCA-T 120VAC,
50/60Hz, 3.5A
ACM
D-BOX LIFESTYLE & LIVING MODELS BY JAYMAR EXPERIENCE
OTHER CUSTOM HAPTIC SYSTEMS
Audio Line-in (Optional)
Flat termination cable must be
connected into the OUT port
Audio Line-in (Optional)
Flat termination cable must be
connected into the OUT port
HAPTIC SEAT
G1 HAPTIC SYSTEM