D-Link SECURICAM Network DCS-6620 User manual

2 D-Link Systems, Inc.
DCS-6620 Install GuideSystem Requirements
System Requirements
Minimum System Requirements:
 Internet Explorer Version 6.0 or above
 CPU Pentium 4, 2.0GHz plus processor

Memory Size: 128MB or above

32MB AGP Video Card
Package Contents

D-Link Systems, Inc. 3
DCS-6620 Install Guide Hardware Overview
Hardware Overview
Front
Power LED
Link LED
Built-In
Microphone
Motorized Zoom Lens

4 D-Link Systems, Inc.
DCS-6620 Install GuideHardware Overview
Rear
Connect the power adapter jack to the PTZ Internet Camera before plugging
in to a power socket. This will reduce the risk of accidental electric shock.
A/V out
External I/O Port
External Mic.
Ethernet 10/100 RJ45 socket
Power Cord socket

D-Link Systems, Inc. 5
DCS-6620 Install Guide Hardware Installation
Hardware Installation
Connect the Ethernet Cable
Connect one end of the Ethernet cable to the network cable connector located on
the back panel of the DCS-6620, and attach the other end to a router, switch, or
gateway on the network.
If you connect this camera
directly to a PC, you will
need a cross-over Ethernet cable.
If you plug the camera into a hub
or router, you will be able to use the
cable included with your camera.
Attach the External Power Supply
Attach the external power supply to the DC
power input connector located on the PTZ
Internet Camera’s backpanel (labeled 12V) and
connect it to an AC power outlet.
Power source is confirmed when
the LED Power Indicator on the
PTZ Internet Camera is illuminated.
Both the red and green LEDs will flash alternately and only the red LED will remain
lit. The green LED will not come on until you have configured your camera.

6 D-Link Systems, Inc.
DCS-6620 Install GuideHardware Installation (continued)
Attach the A/V cable to the A/V out
connector if you wish to connect the
DCS-6620 to your TV set.
Attach the yellow RCA connector to
the “video” connector on your TV.
Attach the white RCA connector to
the “audio” connector on your TV.

D-Link Systems, Inc. 7
DCS-6620 Install Guide Installation Wizard
Installation Wizard
Insert the DCS-6200 CD into the
CD-ROM drive.
Click on Install Software.
Click on Install Wizard.
Click Next

8 D-Link Systems, Inc.
DCS-6620 Install GuideInstallation Wizard (continued)
Click Next
Click Next
Click Finish

D-Link Systems, Inc. 9
DCS-6620 Install Guide Camera Configuration
Camera Configuration
The software will search for cameras.
Double-click on the Installation
Wizard icon, which should have
been created on your desktop.
The Installation Wizard will now show
a MAC address of the DCS-6620 and
an IP Address (which may or may not
be correct depending on what you
have your DCS-6620 connected to).
If you have a DHCP* server on your
network, there will be a valid IP Address
displayed here. After a few seconds, the
“assigned” column will display yes ,
indicating that the displayed IP Address
is now assigned to the camera.
*A DHCP server is a device that supplies IP Addresses to
its clients that are on the same network.

10 D-Link Systems, Inc.
DCS-6620 Install GuideCamera Configuration (continued)
If the Installation Wizard does not display
any devices, you will need to find a
tool small enough to fit into the reset
hole and softly press down a switch for
2 cycles (about 5-7 seconds). The red
and green LEDs will blink continuously
and stop twice. Let go when the red
LED starts to flash the second time.
Once the camera appears,
select the camera by placing
a Checkmark in the box.
Click Search to refresh the
list of cameras if needed.