2 3
Troubleshooting
1. How do I configure my DSL-526B router without the CD ?
• Connect your PC to the router using an Ethernet cable.Connect your PC to the router using an Ethernet cable.
• Open a web browser and enter the address http://192.168.1.1Open a web browser and enter the address http://192.168.1.1
• The default username is �admin’. The default password is �tot’.The default username is �admin’. The default password is �tot’.
• If you have changed the password and can not remember it you will needIf you have changed the password and can not remember it you will need
to reset the router to the factory default setting (steps in question 2) which
will set the password back to �admin’.
2. How do I reset my router to factory default settings?
• Ensure the router is powered on.
• Press and hold the reset button on the rear of the device for 5-8 seconds.
• This process would take about 30~60 seconds to complete.
Note: Resetting the router to factory default will erase the current configuration
settings. To re-configure your settings log into the router as outlined in question
1 then run the Setup Wizard.
3. What can I do if my router is not working correctly?
• The manual contains a full troubleshooting section and can be downloaded
from the D-Link website (see below) however there are a few quick steps
you can take to try and resolve any issues:
• Power the router off for 20 seconds and then power it back on.
• Check that all the cables are firmly connected at both ends.
• Check the LED’s on the front of the router.The Power LED should be on the
Status LED should flash and the DSL and LAN LED should be on as well.
4. Why can I not get an Internet Connection?
• For ADSL ISP users please contact your ISP to make sure the service has
been enabled/connected by your ISP and that your ISP username and
password are correct.