D-Link DWR-921 Setup guide

How to setup the DWR-921
in Bridge Mode

D-Link Technical Support –How to setup DWR-921 in Bridge Mode Page 2of 4
Step 1. Open your Internet browser e.g. Internet Explorer, Firefox, Chrome, Safari, etc. and enter the IP
address of your D-Link modem in the address bar: http://192.168.0.1.
When prompted type in the Username and Password, enter the validation code displayed on your page and
then click on the “Log In”button.
If you have not changed the password for the modem administration, the factory settings are:
Username: admin
Password: admin
If you cannot recall the password you have assigned to your modem, you will need to reset the modem
to factory defaults by pressing the reset button for 10 seconds. Please note that this will revert all the
settings in the modem to factory settings and you will have to reconfigure it with your Internet settings
and Wireless security. Make sure you have your Internet account details (given by your Internet
Provider) handy.

D-Link Technical Support –How to setup DWR-921 in Bridge Mode Page 3of 4
Step 2. After logging in, select “Internet” from the top menu. Then select “WAN Service”.
Set “My Internet Connection”as 4G LTE/3G. Select “Dial-Up Profile” as Manual and fill in your Telco
Provider’s necessary details.
Set “Bridge Ethernet ports”, “NAT disable” and “Transparent Bridge” to Enable. Click on “Apply”.

D-Link Technical Support –How to setup DWR-921 in Bridge Mode Page 4of 4
Step 3. Select “LAN”from the top menu. Then select “DHCP”.
Un-check the “Enable DHCP Server” option. Click on “Apply”.
The configuration is complete, your DWR-921 is now operating in Bridge Mode.
You can use any of the 4 Ethernet ports to connect to a device or another router's WAN Port. The
device or the router’s WAN port needs to be set to Dynamic IP (DHCP) option.