Dahle 40334 Technical manual

QUICK START
Setup Guide
• Unpack The Shredder
• Remove Shipping/Transport Bolts
• Fill Automatic Oiler
For Dahle Shredders

Quick Start - Setup Guide
Unpack The Shredder
• Cut the plastic shipping straps and remove the top box cover.
• Lift & remove the corrugated box sleeve surrounding the shredder
and all packing material.
• Carefully lift the shredder out of the bottom corrugated base. (Please
note - this shredder is suspended on the box material and is top heavy. Be
sure to carefully support the shredder while moving to avoid tipping over.)
Remove The Shipping/Transport Bolts
• To protect your shredder during transport, the cutting head is se-
cured in place with shipping/transport bolts. For removal, open the
shredder door & remove the suspended waste bag.
• Locate the two (or three) recessed shipping bolts inside the cabinet,
directly under the cutting head, and remove them. (A hex key (Allen
Wrench) is provided for your convenience.)
Fill The Automatic Oiler (if applicable)
• Open the cabinet door. If your shredder is equipped with an Even-
Flow Lubricator, it will be located on the inside left of the machine.
• Slide open the drawer like reservoir & lift open the yellow fill cap.
• Pour the entire bottle of oil into the reservoir, insert the yellow cap,
and slide the drawer closed.
Power On The Shredder
• Install the power cord (located inside the cabinet) on the back of the
machine & plug it in.
• Be sure the top of the red emergency shutoff switch is depressed.
• Press the bottom button on the round command dial (located on the
top cover of the machine). This will turn the shredder on.
800.995.1379 / www.dahle.com
North America
®