DAHON WOBBEGONG SLING SACK - 2008 User manual

©2008 Dahon | www.dahon.com/support/manuals.htm
A. Prepare your Wobbegong
Step 1. Turn the handlebars 180degrees and
slide the seat post to the lowest position. Fold
the pedals and protect the main tube of the
bicycle with the protective cloth included
with each bag. (see Fig. 1)
Fig. 1
Step 2. Loosen the handlebar stem binder
screws on the stem with a 5mm Allen wrench.
(See Fig. 2)
Fig. 2
Step 3. Make sure the removed stem and
handlebar are placed on the left (non-chain
wheel) side of the bicycle. (See Fig. 3)
Fig. 3
B. Pack the Wobbegong in the Sling Sack
Step 1. Take the Sling sack out of its protective
bag and unfold it.
Step 2. Open the autolock zippers, the head
and saddle straps. (Note: the zippers stay on
the derailleur side of the bicycle.
Step 3. Place the Sling Sack over the bike
allowing the seat post/saddle to protrude
from the upper bag opening. Secure the seat
post/saddle strap to prevent the bag from
dropping. This will allow you to handle the bag
more easily when fitting the wheels into the
bag. (See Fig. 4)
Fig. 4
Step 4. Fit the front wheel into the bag by
placing the front flap on the tire and then
rolling the bike forward. (See Fig. 5)
Fig. 5
The Dahon Sling Sack -
The simplest way to carry your Dahon Wobbegong
A B

©2008 Dahon | www.dahon.com/support/manuals.htm
Step 5. Fit the rear wheel into the bag by
placing the rear bag flap on the tire and
rolling the bike carefully backwards. Make
sure that the flap does not interfere with the
derailleur. (See Fig. 6)
Fig 6.
Step 6. Place the supplied cover on the stem
and place the stem/handlebar in the inside
pocket of the Sling Sack. Secure the stem/
handlebar strap and the hand grip.
(See Fig. 7)
Fig. 7
Step 7. Lower the side flap and zip the
autolock zippers/ (Double check the pull tab
of the zipper is in the “locked” position and
attach the shoulder strap. (See Fig. 8)
Fig. 8