Dakota Alert UT-3000 User manual

Driveway Radio User Manual
UT-3000 Transmitter:
The UT-3000 transmitter has several methods of activation. First, it has a push button that can be
used as a panic button or doorbell. It also has terminals for a normally open (N/O) or normally
closed (N/C) input. When the transmitter is activated, it will send a signal to the receiver which
will sound one of four different tones (Classical, Westminster Chime, Ding Dong, or Whistle) for a
few seconds, or activate the relay outputs.
Operation:
Swing open the bottom of the front cover to reveal the battery connector, dip switches and input
terminals.
Connect a 9V alkaline battery to the transmitter.
Set the dip switches 1-8 on the transmitter module to match the receiver.
Set dip switches 9 and 10 to control the desired zone, tune, and relay output.
Operation:
Power ON/OFF
Press the side button 2 seconds for Power ON or Power OFF.
Time Setting
Press Side Button once, the receiver goes into the Time Setting mode. Press the left button on the
front to the digit you want to change, and press right button on the front to modify the number.
After modification, press side button to save the setting and move to Vibration Setting mode.
Vibration
Press side button twice, the receiver goes into the Vibration Setting mode. Press right button to
change it ON/OFF.
Beep / Silent
Press Side Button 3 times, the receiver goes into Beep / Silent mode. Press right button to change
ON/OFF.
ID Code Checking
Press Side Button 4 times to check the ID code you have already set. The ID code must be same
as the transmitter.
Alarm
Normally, the display shows the time. It also receives signals from transmitter automatically.
When there is an alarm, the receiver will do the following:

1). Record the time and channel (up to 9999 / channel);
2). Display the time and channel (up to 250 / channel);
3). Give alarm by vibration or Beep according to the setting of the unit. Channel 1 has one beep
sound, channel 2 two beeps, channel 3 3beeps, and channel 4 four beeps.
4) The display can only be cancelled by the user (press DN) or there is a new alarm to cover the old
one.
Battery Low
When the CPU detects battery low, the receiver will do the following:
1) Give is a short Beep per 10 minutes to remind user of changing battery;
2) When the battery is lowered to certain voltage, memorize the time and turn off the unit.
Key Lock / Key Lock Release
In the normal time display, Press left button, at the same time press right button.
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance will void the user’s authority to operate the equipment. Any change to the equipment
will void FCC grant.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or an experienced radio/TV technician for help.